Installation guide

Interconnection-6
Figure 4. Interconnect chart for locating correct cable assemblies on the following pages.
Note: (A) This configuration uses an “off-the-shelf” cable.
Note: (B) This configuration causes a 6 dB signal loss. Compensate by “turning the system up” 6 dB.
To Input
MALE
BALANCED XLR
¼" BALANCED
TRS (TIP-RING-SLEEVE)
¼" OR 3.5mm
UNBALANCED
TS (TIP-SLEEVE)
UNBALANCED RCA BALANCED
EUROBLOCK
From Output
1234
6521
10987
121187
12112221
16 23
23
151413
20
2424
191817
BB
BB
AA
AA
AA
FEMALE BALANCED XLR
(NOT A TRANSFORMER,
NOR A CROSS-COUPLED
OUTPUT STAGE)
FEMALE BALANCED XLR
(EITHER A TRANSFORMER
OR A CROSS-COUPLED
OUTPUT STAGE)
¼” BALANCED TRS
(NOT A TRANSFORMER,
NOR A CROSS-COUPLED
OUTPUT STAGE)
¼” BALANCED TRS
(EITHER A TRANSFORMER
OR A CROSS-COUPLED
OUTPUT STAGE)
¼” FLOATING UNBALANCED
TRS (TIP-RING-SLEEVE)
(SLEEVE IN UNIT = NC)
¼” OR 3.5 mm
UNBALANCED
TS (TIP-SLEEVE)
UNBALANCED RCA
(TIP-SLEEVE)
CABLE
CONNECTORS
BALANCED
EUROBLOCK
+ to +
–
to –
SHIELD ONLY
TO XLR PIN 1
+
to
+
–
to –
SHIELD NC
+ to +
–
to
–
SHIELD NC
+ to +
–
to
–
SHIELD ONLY
TO EUROBLOCK
+ to +
–
to
–
SHIELD NC
+ to +
–
to –
SHIELD ONLY
TO TRS SLEEVE
+ to +
–
to –
GROUND to GROUND
+ to +
–
to –
GROUND to GROUND