Installation manual

MONGOOSE

Installation Manual

Note: If your system contains multiple devices and you are unsure of which one to open, use

the Locate functionality to ﬁnd the corresponding physical device. See "Locating a Hardware

Device" on page 29 for details.

5. Load the conﬁguration ﬁle.

a. Click the Load icon in the toolbar.

is opens a browse dialog box from which you can select the conﬁguration ﬁle to load.

b. Select the ﬁle you want and click OK. e conﬁguration settings are immediately applied and

saved to the Mongoose. If the Mongoose detects any mismatches between the conﬁgured RADs

and the physical RADs connected to the Mongoose, these mismatches are reported in the RAD

area. If you are loading the conﬁguration prior to installing any RADs, each conﬁgured RAD

port will report an error. is is because it expects to ﬁnd a connected RAD, but instead it ﬁnds

nothing. When the correct RAD models are installed, these errors disappear. Troubleshooting

the conﬁguration is described in more detail on "Verify the RAD Conﬁguration" on page 27.

6. Click the Edit Notes icon at the top of the RAD area: . Here you can review notes the

audio designer may have included with any special instructions. You can change the font size by

clicking Settings in the toolbar and adjusting the Font Size setting.

7. In upper left corner edit box, type the name for this Mongoose (if it needs a new name). is device

name is saved to the device, but it is not saved to the conﬁguration ﬁle (to avoid naming collisions

if you were to load the same conﬁguration ﬁle into another device):

8. Make any other edits necessary to complete the conﬁguration. Typically, none are needed.