Installation manual

MONGOOSE
Installation Manual
29
Locating a Hardware Device
If you want to doublecheck which physical hardware device you are viewing within the software, try using
the Locate feature. is feature is available for both RAD and Mongoose devices. Within the Mongoose
Tracker, you’ll see a Locate button for the Mongoose as well as for each RAD. e following screen shot
points out these buttons:
To locate a Mongoose, click the Locate button near the Mongoose name in the upper left corner of the
screen. is causes the Locate LED indicator on the front and rear panels of the corresponding
Mongoose to flash.
e LED continues to flash until you deselect the Locate button in the software, place another Mongoose
in Locate mode, disconnect from the device, shut down the software, or cycle power to the Mongoose.
To locate a RAD, click the Locate button associated with the RAD you want to find.
is causes the bottom four status LEDs on the RAD to flash green (as opposed to flashing red which
indicates a model mismatch). ese LEDs continue to flash until you deselect the Locate button in the
software, place another RAD in Locate mode, disconnect the RAD, shut down the software, or cycle
power to the Mongoose.
Note: As outlined above, the bottom four status LEDs flash green to indicate Locate mode and flash red to
indicate a model Mismatch. To aid those that may have difficulty distinguishing the two colors, the rate at
which these LEDs flash is also different for each mode. e rate for indicating a model mismatch (flashing
red) is twice as fast as the rate used to indicate locate mode (flashing green).