Owner's Manual
NOTICE CONCERNING LASER PRODUCTS: DANGER: INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR
DEFEATED. AVOID DIRECT EXPOSURE TO BEAM. USE OF CONTROLS OR ADJUSTMENTS OTHER THAN THOSE SPECIFIED
HEREIN
MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE.
NOTICE CONCERNING
FCC
REGULATIONS: You are cautioned that changes
or
modifications not expressly approved
by
the part
responsible
for
compliance could void
the
user's authority
to
operate the equipment. This equipment has been tested and found
to
comply
with
the
limits
for
a Class B digital device, pursuant
to
Part 15
of
the
FCC rules. These limits are designed
to
provide
reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and,
if
not installed and used in accordance with the instructions,
may
cause harmful interference
to
radio
communications. However, there is no guarantee
that
interference will
not
occur
in a particular installation. If this equipment does
cause harmful interference
to
radio
or
television reception, which can
be
determined
by
turning
the
equipment
off
and on, the user is
encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the following measures:
(a)
reorient
or
relocate the receiving antenna;
(b)
move
this
unit;
(c)
increase the separation between
the
equipment and receiver;
(cl)
connect
the
equipment into an outlet on a
circuit different from
that
to
which the receiver is connected;
(e)
be sure that all cables are properly shielded, using a choke
or
ferrite
where appropriate;
or
(f)
consult
the
dealer or an experienced radio/television technician
for
help.
This device complies with Part 15
of
the FCC rules. Operation is subject
to
the following
two
conditions:
(1)
this device may not cause
hannful interference, and
(2)
this device must accept any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth
for
an uncontrolled
environment. End users
must
follow
the
specific operating instructions
for
satisfying
RF
exposure compliance. This transmitter must
not
be
co-located
or
operating in conjunction with any other antenna
or
transmitter.
For Canadian models:
• This device complies with Industry Canada licence-exempt
RSSs.
Operation
is
subject
to
the following two
conditions:
(1)
this device may not
cause interference, and
(2)
this device must accept any interference, including interference
that
may cause undesired operation of the device.
• Under Industry Canada regulations, this radio transmitter may only operate using
an
antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada To reduce potential radio interference
to
other users, the antenna
type
and its gain should
be
so chosen
that
the equivalent isotropically radiated power (e.i.r.p.}
is
not more than
that
necessary for successful communication.
• This radio transmitter (identify the device
by
certification number,
or
model number if Category
II)
has been approved
by
Industry
Canada
to
operate with the antenna types listed
below
with
the
maximum permissible gain and required antenna impedance for
each antenna
type
indicated. Antenna
types
not included in
this
list, having a gain greater than
the
maximum gain indicated for
that type, are strictly prohibited
for
use with this device.
• This unit does
not
exceed the Class B limits
for
radio noise emission from digital apparatus set
out
in
the
radio interference
regulations
of
the
Canadian Department
of
Communications.
~
ESD/EFT Warning: This unit may contain a microcomputer
for
signal processing and control functions.
In
very rare
11
.,
_
-4.
situations, severe interference, noise from an external source,
or
static electricity
may
cause it
to
lock up.
In
the unlikely event
~
that this should happen,
tum
off
the
unit, wait at least five seconds, and then
tum
it back on again. The pins
of
connectors
identified with this ESD warning symbol should not
be
touched.
For best audio quality, avoid using this device in a high RF-radiated environment.
In
an environment with radio frequency interference,
the unit
may
malfunction and resume normal operation after removal
of
the
interference.
For 240-volt use in U.K., use NEMA®-style 240-volt plug. For other countries use proper
plug
for
local outlet.
Double-Insulated: When servicing use only identical replacement parts.
Correct Disposal of This Product This marking indicates that this product should not
be
disposed with other household wastes
throughout the
EU.
To prevent possible hann
to
the environment
or
human health from uncontrolled waste disposal, recycle it
responsibly
to
promote the sustainable reuse
of
material resources. To return your used device, please use the return and collection
- systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.
Disposal
of
Batteries (if applicable):
• Never dispose
of
any types
of
batteries in fire
or
near excessive heat
or
direct sunlight. Overheated batteries can rupture or explode.
•
If
you are unsure
of
how
or
where
to
dispose
of
a battery, refer
to
your local ordinances
for
the proper location, method, etc.
• Alkaline batteries & lithium button cell batteries: You can safely dispose
of
alkaline and lithium button cell batteries with
normal household waste. They
do
not
pose a health
or
environmental risk during normal use
or
disposal. (Alkaline batteries are
composed primarily
of
common metals like steel, zinc, and manganese.)
Do not dispose
of
large amounts
of
alkaline
or
lithium button cell batteries in a group. Used batteries are often
not
completely
"dead." Grouping them together can bring these "live" batteries into contact with one another, creating safety risks. To avoid this,
insulate each battery with
tape
or
other non-conductive material
to
ensure it
does
not
discharge.
Proven cost-effective and environmentally safe recycling processes are not yet universally available
for
alkaline and lithium button
cell batteries. Some communities offer recycling
or
collection
of
these batteries. For more information, refer
to
your local
ordinances
or
contact
your local government.
• Lead-acid batteries: Dispose
of
lead-acid batteries
by
bringing them
to
an electronic waste center
or
recycling center,
or
dispose
of
them in accordance with your local ordinances. (Rechargeable lead-acid batteries are
the
same
type
used in
automobiles and should be disposed
of
in a similar fashion.)
California Proposition
65
Warning: This
product
may contain chemicals known
to
the
State
of
California
to
cause cancer and birth
defects
or
other
reproductive harm. (California law requires this warning
to
be given
to
customers in the State
of
California.)
C
E:
General Note on the Declaration of Conformity: We hereby declare that this device is in accordance
with the essential requirements
of
the
European Directive 1999/5/EC. The full
EU
declaration
of
conformity can
be
requested
at
the following address:
7
inMusic GmbH
Harkortstr. 12 - 32
40880 Ratingen
GERMANY