User guide

Manual-2
INPUT LEVEL control and indica-
tors
This controls the overall level
without altering the relative settings of
the Low and High frequency Outputs.
Input gain is +6 dB at “10”. With signal
applied, set this control so the +4 dBu
LED lights occasionally, indicating
sufficient signal. Flashing of the OL
(overload) LED during peaks can be
avoided by turning the INPUT LEVEL
down.
LOW LEVEL control
This controls the level of signal
going to the LOW OUTPUT jacks.
Unity gain is reached at the “0 dB”
mark with the INPUT LEVEL set to
“10”. This control does not affect the
MONO SUB OUTPUT level. Refer to
Operating Instructions on page Manual-
6.
HIGH OUTPUTS
These are balanced Output jacks.
Connect the LEFT HIGH OUTPUT to
the left channel input of the high
frequency amplifier, and the RIGHT
HIGH OUTPUT to the right channel
input of the high frequency amplifier.
When using different model amplifiers
for the low and high outputs, use the
amplifier with the most power for the
low outputs.
LOW OUTPUTS
Connect the LEFT LOW OUTPUT
to the left channel of the low frequency
amplifier, and the RIGHT LOW
OUTPUT to the right channel of the low
amplifier. When driving a single
subwoofer, use the MONO SUB
OUTPUT jack instead.
MONO SUB OUTPUT
LEVEL control
This controls the level of the
summed signals of the LEFT and
RIGHT LOW OUTPUTS. It may be
used instead of, or along with the LOW
OUTPUTS. The output may be adjusted
with the LEVEL trim from +0 dB to
OFF. Unity gain is reached at the “0
dB” mark with the INPUT LEVEL set
to “10”.