Owner`s manual
OWNER’S MANUAL
13
SIXTY-TWO
Deck Input Channels
Two input channels, or buses, have nearly identical controls with the exception of the Source selectors.
Source Selector
The SOURCE selector for Deck 1 selects one of four
sources:
•
A Left Virtual Deck (USB stereo playback pair
1-2) from USB A.
• Also assigns the MIDI controls for the Left Deck
software and Deck 1 mixer to USB A.
• PH / CD 1 (THRU): Set to PH or CD on the rear panel.
• When selected in software, this input is available
on USB record 5-6 for use as the DVS control
signal or for audio recording. To select this control
source in Serato DJ: go to Setup > Audio > Deck
Setup > PGM 1 and select “1”.
• PH / CD 2 (THRU): Set to PH or CD on the rear panel.
• When selected in software, this input is available
on USB record 5-6 for use as the DVS control
signal or for audio recording. To select this control source in Serato DJ: go to Setup > Audio > Deck
Setup > PGM 1 and select “2”.
•
B Left Virtual Deck (USB stereo playback pair 1-2) from USB B.
• Also assigns the MIDI controls for the Left Deck software and Deck 1 mixer to USB B.
The SOURCE selector for Deck 2 selects one of four sources:
•
A Right Virtual Deck (USB stereo playback pair 3-4) from USB A.
• Also assigns the MIDI controls for the Right Deck software and Deck 2 mixer to USB A.
• PH / CD 3 (THRU): Set to PH or CD with the rear panel switch.
• When selected in software, this input is available on USB record 7-8 for use as the DVS control signal
or for audio recording. To select this control source in Serato DJ: go to Setup > Audio > Deck Setup >
PGM 1 and select “3”.
• PH / CD 4 (THRU): Set to PH or CD with the rear panel switch.
• When selected in software, this input is available on USB record 7-8 for use as the DVS control signal
or for audio recording. To select this control source in Serato DJ: go to Setup > Audio > Deck Setup >
PGM 1 and select “4”.
•
B Right Virtual Deck (USB stereo playback pair 3-4) from USB B.
• Also assigns the MIDI controls for the Left Deck software and Deck 2 mixer to USB B.
Level
LEVEL controls adjust the input gain from off to +15 dB. Unity gain (no boost or cut) is at 12 o’clock.
Pan
Left / Right PAN controls adjust the balance of left and right signals. Left and right are equal at 12 o’clock .
Tone Controls
HIGH, MID and LOW full-cut isolator tone controls adjust the frequency response from off to +6 dB. Unity
gain (no boost or cut) is at 12 o’clock.
CUE
DECK 1
CUE
USB AUX
CUE
DECK 2
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
HIGHLOW
10
0
2
4
8
6
MAINCUE
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
RIGHTLEFT
+6OFF
+6OFF
+6OFF
+6OFF
+6OFF
+6OFF
+6OFF
+6OFF
HIGHLOW
RIGHTLEFT
HIGHLOW
SYNC
BYPASS CLEAN FEED
SYNC OFF
START / STOPNUDGEBPM
SLIP
SYNC
SYNC OFF
SLIP
B B
A A
DECK 1
MIC
DECK 1
AUX
SP-6 ASSIGN ON OVER
HIGH
LEVEL
LOW
FLEXFX
INSERT
TIME TAP
CUES 1 2 3 4 5
C D
543
SAMPLES 4 5 6321
21
BA
ON
CUE
EXT. INSERTFILTER
BEAT
FLANGER PHASER ECHO ROBOT REVERB
FLEXFX
BACK
LOAD
SCROLL
LOOPS
BEATS SELECT SELECT
SHIFT SHIFT
LEVEL
FILTER
FLEXFX
AUTO MANUAL
LOOP IN
ROLL OUT
SAVE
BEATS
LOOP
ROLL
SAVELOOP
IN
OUT
LOOP
DECK 2
MIX DECK 2
LEVEL
PHONES
SP-6 ASSIGN
BACK
LOAD
SCROLL
LOOPS
LEVEL
PAN
SPLIT CUE
MANUAL AUTO
LOW
MID
HIGH
LEVEL
MAIN
SESSION OUT
SESSION IN
BOOTH
LOW
DEPTH
MID
HIGH
PH / CD PH / CD
SOURCE
PAN
1 2
FILTER
FLEXFX
SOURCE
PAN
3 4
FILTER
FLANGER +Fb
BPM:120 * 1:1
4000 ms