Britain’s No.
RANGEMASTER COOKWARE Our range cookers are well known for providing the best possible cooking performance and years of faithful service. However, a great cooker alone cannot guarantee perfect results every time. The other vital ingredients are of course enthusiasm and quality cookware. We offer cookware to work perfectly with all fuel types manufactured by Rangemaster, including induction hobs.
Contents 1. 2. 3. Before You Start... 1 6. Troubleshooting 18 Important! 1 Installation and Maintenance 1 7.
ii
1. Before You Start... If You Smell Gas Your cooker should give you many years of trouble-free cooking if installed and operated correctly. It is important that you read this section before you start, particularly if you have not used a dual fuel cooker before.
Foods for frying should be as dry as possible. Frost on frozen foods or moisture on fresh foods can cause hot fat to bubble up and over the sides of the pan. Carefully watch for spills or overheating of foods when frying at high or medium high temperatures. Never try to move a pan of hot fat, especially a deep fat fryer. Wait until the fat is cool. Always be certain that the controls are in the OFF position when the oven is not in use, and before attempting to clean the cooker.
2. Cooker Overview Fig.2-1 A B C E D The 100 dual fuel cooker (Fig.2-1) has the following features: A. B. C. D. E. Fig.2-2 5 hotplate burners including a wok burner A control panel A glide-out grill Main multi-function oven Tall fan oven Hotplate Burners The drawing by each of the central knobs indicates which burner that knob controls. Each burner has a Flame Supervision Device (FSD) that prevents the flow of gas if the flame goes out.
If, when you let go of the control knob, the burner goes out, then the FSD has not been bypassed. Turn the control knob to the OFF position and wait for one minute before you try again, this time making sure to hold in the control knob for slightly longer. Fig.2-3 Adjust the flame height to suit by turning the knob counterclockwise (Fig.2-3). On this cooker the low position is beyond high, NOT between high and off.
The Wok Cradle Fig.2-9 The wok cradle is designed to fit a 35 cm wok. If you use a different wok, make sure that it fits the cradle. Woks vary very widely in size and shape. It is important that the wok sits down on the pan support – however, if the wok is too small, the cradle will not support it properly (Fig.2-9). The cradle should be used on the wok burner only. When you fit the cradle, make sure that it is supported properly on a pan support and the wok is sitting level in the cradle (Fig.2-10).
The Glide-out Grill Fig.2-15 Open the door and pull the grill pan carriage forward using the handle (Fig.2-15). The grill has two elements that allow either the whole area of the pan to be heated or just the right-hand half. Adjust the heat to suit by turning the knob. To heat the whole grill, turn the knob clockwise (Fig.2-16). To heat the right-hand half, turn the knob counter-clockwise. The neon indicator light by the grill control will come on. ArtNo.
Fan Assisted Oven The multi-function ovens have many varied uses. We suggest you keep a careful eye on your cooking until you are familiar with each function. Remember – not all functions will be suitable for all food types. This function operates the fan, circulating air heated by the elements at the top and the base of the oven. The combination of fan and conventional cooking (top and base heat) makes this function ideal for cooking large items that need thorough cooking, such as a large meat roast.
wash the shelf and tray after defrosting. Fig.2-18 Defrost with the oven door closed. ArtNo.235-0003 - Classic DL MF knobs Large items, such as whole chickens and joints should not be defrosted in this way. We recommend this be carried out in a refrigerator. Defrosting should not be carried out in a warm oven or when an adjoining oven is in use or still warm. Make sure that dairy foods, meat and poultry are completely defrosted before cooking.
The Clock Fig.2-21 You can use the timer (Fig.2-21) to turn the left-hand oven on and off. The clock must be set to the time of day before this oven will work. Note: When using the timer functions, first set the clock as required before setting the oven temperature and selecting the oven function (multi-function ovens only). ArtNo.302-0002 - 6BC annotated Setting the Time of Day A When the clock is first connected the display flashes ( 0.00 ) and ( ) alternately.
Fig.2-31 beep; press it again to return to manual cooking. Fig.2-32 ArtNo.302-0008 Activating the key lock 1 If you are out, do not worry about the beeper going off, it stops after a while. When you return, turn the oven knob to 0 first, and then press [] twice to return to manual cooking. ArtNo.302-0009 - Activating the key lock 2 Fig.2-33 AUTO is Showing, You Want to Reset to Manual Cooking To return to manual cooking from any automatic setting, the ‘cook period’ must be cancelled.
Accessories Fig.2-36 Flat shelf Oven Shelves – Left-hand (Main) Oven In addition to the flat shelves, your cooker is supplied with a drop shelf (Fig.2-36). The drop shelf increases the possibilities for oven shelf spacing. Shelf guard Front The oven shelves can be easily removed and refitted. Pull the shelf forward until the back of the shelf is stopped by the shelf stop bumps in the oven sides (Fig.2-37).
3. Cooking Tips Tips on Cooking with the Timer General Oven Tips If you want to cook more than one dish, choose dishes that require approximately the same cooking time. However, dishes can be ‘slowed down’ slightly by using small containers and covering them with aluminium foil, or ‘speeded up’ slightly by cooking smaller quantities or placing them in larger containers. The wire shelves should always be pushed firmly to the back of the oven.
4. Cooking Table DocNo.031-0004 - Cooking table - electric & fan single cavity The oven control settings and cooking times given in the table below are intended to be used AS A GUIDE ONLY. Individual tastes may require the temperature to be altered to provide a preferred result. Food is cooked at lower temperature in a fan oven than in a conventional oven. When using recipes, reduce the fan oven temperature by 10 °C and the cooking time by 5-10 minutes.
5. Cleaning Your Cooker Isolate the electricity supply before carrying out any thorough cleaning. Allow the cooker to cool. Fig.5-1 A NEVER use paint solvents, washing soda, caustic nn cleaners, biological powders, bleach, chlorine based C bleach cleaners, coarse abrasives or salt. B DO NOT mix different cleaning products – they may nn react together with hazardous results. All parts of the cooker can be cleaned with hot soapy water – but take care that no surplus water seeps into the appliance.
The Griddle Fig.5-5 Always clean the griddle after use. Allow it to cool completely before removing. Immerse the griddle plate in hot soapy water. Use a soft cloth or, for stubborn stains, a nylon washing up brush. Note: If the griddle is washed in a dishwasher then some dishwasher residue may appear on the back. This is normal and will not affect the performance of your griddle. Glide-out Grill ArtNo.331-0001Grill pan pulled forwards Before you remove any of the grill parts for cleaning.
Glass Fronted Door Panels Fig.5-10 The oven door front panels can be taken off so that the glass panels can be cleaned. Move the cooker forward to gain access to the sides (see the ‘Moving the Cooker’ section under ‘Installation’). Open the oven door slightly and remove the front panel fixing screws from the door sides, two each side (Fig.5-10). Carefully lift off the outer door panel. The inside face of the glass panels can now be cleaned – take care not to disturb or wet the door insulation. ArtNo.
Cleaning Table Cleaners listed (Table 5-1) are available from supermarkets or electrical retailers as stated. For enamelled surfaces use a cleaner that is approved for use on vitreous enamel. Regular cleaning is recommended. For easier cleaning, wipe up any spillages immediately. Hotplate Part Finish Recommended Cleaning Method Hob top (including burner heads and Enamel or stainless steel caps) Hot soapy water, soft cloth. Any stubborn stains remove gently with a nylon scourer.
6. Troubleshooting Hotplate ignition or hotplate burners faulty Is the power on? Is the clock illuminated? If there is an installation problem and I don’t get my original installer to come back to fix it who pays? You do. Service organizations will charge for their call outs if they are correcting work carried out by your original installer. It is in your interest to track down your original installer. If not, there maybe something wrong with the power supply.
Oven temperature getting hotter as the cooker gets older If turning the temperature down using the oven control knob has not worked, or has only worked for a short time, then you may need a new thermostat. This should be fitted by a service person. Fig.6-1 ArtNo.324-0005 Oven light bulb An oven light is not working The bulb has probably burnt out. You can buy a replacement bulb (which is not covered under the warranty) from a good electrical shop. Ask for a 15 W – 230 V lamp, FOR OVENS.
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. 7. Installation Dear Installer In the UK the cooker must be installed in accordance with: Before you start your installation, please complete the details below, so that, if your customer has a problem relating to your installation, they will be able to contact you easily. • • • Installer’s Name Installer’s Company • • ArtNo.
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. Checking the Parts: Location of Cooker The cooker may be installed in a kitchen/kitchen diner but NOT in a room containing a bath or shower. 3 pan supports Griddle Wok cradle Grill pan and trivet This appliance is designed for domestic cooking only. Use for any other purpose could invalidate any warranty or liability claim.
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. Fig.7-1 Positioning the Cooker ArtNo.090-0009 - 90 2BC cooker min spacings 75 mm min 650 mm min Fig.7-1 and Fig.7-2 show the minimum recommended distance from the cooker to nearby surfaces. 75 mm min The cooker should not be placed on a base. Above hotplate surround should be level with, or above, any adjacent work surface.
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. Lowering the Two Rear Rollers Fig.7-5 To adjust the height of the rear of the cooker, first fit a 13 mm spanner or socket wrench onto the hexagonal adjusting nut (Fig.7-5). Rotate the nut – clockwise to raise – counterclockwise to lower. Make 10 complete (360°) turns clockwise. Make sure you lower BOTH REAR ROLLERS. Completing the Move Unfold the rear edge of the cardboard base tray.
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. Repositioning the Cooker Following Connection Fig.7-10 If you need to move the cooker once it has been connected then you need to unplug it and, having gripped under the fascia panel and lifted the front of the cooker slightly (Fig.7-6), you need to check behind the cooker to make sure that the gas hose is not caught. ArtNo.
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. Gas Connection Fig.7-12 This must be in accordance with the relevant standards. 750 The flexible hose (not supplied with the cooker) must be in accordance with the relevant standards. Hoses may be purchased at most builders’ merchants. 500 Gas inlet We recommend that a Micropoint gas hose is used when installing this appliance.
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. Electrical Connection Fig.7-13 The cooker must be installed by a qualified electrician, in accordance with all relevant British Standards/Codes of Practice (in particular BS 7671), or with the relevant national and local regulations.
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. 8. Conversion to LP Gas Check the ‘Technical Data’ section at the back of the book that the hob is convertible to the gas you want to use. A suitably competent person must perform the conversion. After conversion the installation must comply with the relevant regulations and also the local electricity supply company requirements.
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. Pressure Testing Connect the appliance to the gas supply. The gas pressure can be measured at one of the hotplate burner jets (not a wok burner). Lift off a burner head. Fit the pressure gauge to the jet. Turn on and light one of the other burners with a match.
9.
10. Technical Data THE COOKER IS CATEGORY: CatII2H3+. It is supplied set for group H natural gas. A conversion kit from NG to LP is available for the cooker. INSTALLER: Please leave these instructions with the user. DATA BADGE LOCATION: Cooker back, serial number repeater badge below oven door opening. COUNTRY OF DESTINATION: GB, IE, FR, NL, DE, SE, AT, BE, CH, LU, IT.
For warranty compliance, the requirements are that the appliance: Name of Appliance & Colour* • Has been correctly installed in accordance with current legislation, relevant British and European Standards and Codes of Practice, by a suitably competent person registered with Gas Safe or equivalent body and, where applicable, a qualified electrician. • Has been used solely for domestic cooking purposes. • If in use in the UK*, has not been taken abroad as a personal export.
ALSO PART OF THE RANGEMASTER COLLECTION... Refrigeration Built-in Cooking Dishwashing Sinks & Taps Clarence Street Royal Leamington Spa Warwickshire CV31 2AD England Tel: +44 (0) 1926 457400 Fax: +44 (0)1926 450526 E-mail: consumers@rangemaster.co.uk Consumer Services Tel: +44 (0) 870 7895107 www.rangemaster.co.uk Britain’s No.1 Range Cooker For ROI Enquiries Tel: 1850 302 502 Search Rangemaster UK Registered in England and Wales. Registration No.
