User guide

10
560 - 570
596 ref.
1780
38 min
550
Exterior door tting requirements are subject to the kitchen
furniture specication.
Dimensions in millimetres.
Positioning Your Appliance
IMPORTANT: We recommend that two people install this
appliance.
Choosing the Right Location
The appliance should be installed in a location where
the ambient temperature corresponds with the climate
classication as stated on the rating plate.
Your appliance may not function correctly if the ambient
temperature falls outside of the following ranges.
Climate
classication
Appropriate ambient
temperature
SN +10 to +32 °C
N +16 to +32 °C
Avoid exposing the appliance to direct sunlight and sources
of heat (such as radiators, heaters or cookers).
The door should be able to open completely and freely.
Locate the appliance so you can easily access the food that is
stored in it.
Make sure there is an electrical socket available which will be
accessible after your appliance is installed.
Fig.4-1 shows the required cabinet dimensions.
If this appliance is situated in a cold environment (such as
a shed, outhouse or garage) it will aect its performance.
You may nd that the performance of the appliance is
not consistent and this may damage foods. A consistent
ambient temperature of 10 °C or above is recommended.
Reversing the Doors
The doors of your fridge-freezer can be set to open from the
left or the right. If you want the door to hinge on the left-
hand side and open from the right-hand side, then follow the
proecedure below.

This procedure MUST be completed before the
furniture door is attached.
When reversing a door, keep any parts that you remove from
the appliance for later use.

Take care when unscrewing any of the hinges: hold
the door to stop it from falling and causing damage.
Tools required:
• Phillips screwdriver
• Flat bladed screwdriver
4. Installation
Fig.4-1