User guide

Cabinet hinge screws

Procedure

Loosen the cabinet hinge screws and carefully slide

the door o (Fig.4-2). To stop the door from being

damaged, place it on a cushioned surface.

2. Lever o the cover caps on the left-hand side of the

appliance cabinet (Fig.4-3).

3. Undo the door hinge screws and remove the hinges.

4. Reverse the position of the top and bottom hinges

and t them to the left-hand side of the door (Fig.4-4).

Secure in place using the door hinge screws.

5. Slide the door onto cabinet hinge screws. Tighten the

screws to secure.

6. Insert the cover caps into the holes on the right-hand

side of the cabinet.

IMPORTANT: After you have completed reversing the door,

check that the door opens and shuts correctly without

fouling.

You should also check the appliance door seals. The seal

should not be creased or crushed; otherwise there will be a

gap between it and the inside of the door.

The seal must bond properly all the way around the door. If

the seal is not bonding to the appliance properly, then you

should either:

A. Use a warm damp cloth and adjust the seal until it

bonds to the appliance properly, all the way around the

door, or

B. Use a hairdryer on its lowest heat setting and lightly

heat the areas of the door seal that are not bonding

correctly. The heat will make the seal more pliable and

this will allow you to adjust the seal into the correct

position.

IMPORTANT: DO NOT heat the door seal on anything but

the lowest heat setting or heat the seal for a long period

of time, otherwise you may damage the door seal, which

would NOT be repaired under the guarantee free of charge.

The appliance must be stood on a level oor. You can use the

levelling feet to take into account any minor unevenness in

the oor.

Fig.4-2

Fig.4-3

Fig.4-4