DxD 910 Refrigerator User Guide & Installation & Service Instructions U109923 - 05
Contents 1. Before You Start 1 2. About Your Refrigerator 2 3. Food Storage Tips 8 4. Installation 10 5. Cleaning and Maintenance 13 6. Troubleshooting 16 7. Warranty/After Sales Service 20 8.
1. Before You Start Thank you for buying a Rangemaster appliance. We hope that it provides a stylish yet practical solution to your cooling needs. We hope that this handbook supplies you with all the information you require. If there is anything you are unsure of please contact us (see Warranty section for Customer Care’s details). • • WARNING: This appliance must be earthed. Please leave the appliance to stand for at least six hours.
2. About Your Refrigerator Fig.2-1 ������������� ����������������� ����������� ����������������� ������������������������� ���������������� ���������������� ������������������������� �������� ����������������� ����������� �������������������� �������������� ArtNo.600-0004 - Refrigerator layout ������������������������ • • The refrigerator is shown in Fig.2-1 and has the following features: • • • Water filter: This unit comes equipped with a chlorine and odour free filter.
About the Fresh Food Compartment Fig.2-2 It is recommended to leave storage space between the foods for good cold air circulation. The temperatures in the refrigerator are slightly warmer near the top and colder near the base. Suggestions for storage (Fig.2-2): 1. 2. Eggs, butter, cheese etc. Tins, cans, condiments, etc. 3. 4. 5. 6. 7. 8. Drinks and all kinds of bottled foods. Pickled foods, drinks or cans. Meat, poultry, fish and raw foods. Flour foods, cans, dairy, etc. Cooked meats, sausage, etc.
Bottle Rack Height Adjustment Fig.2-6 Hold both sides of the bottle rack then lift and pull it straight out for cleaning or to change location (Fig.2-7). After cleaning, the bottle rack can be installed in the reverse manner, and the position can be adjusted according to the height of the food to be stored. When adjusting the height of the bottle rack, it is better to house the dairy bin above the bottle rack. When opening or closing the dairy bin, please take care not to trap your fingers (Fig.
Fig.2-11 ArtNo.
The freezer will remain in this mode for 4 hours. You can press the Quick Freeze button after 3 hours if you wish to end the quick-freeze mode early. Fig.2-17 Water Filter Settings ArtNo.600-0043 - Water supply settings When the water filter indicator light is illuminated this means the water filter should be changed. After the water filter is changed, press the Water Filter Reset button (Fig.2-16) – the water filter indicator light will go out. Fig.
Control Centre Power Down After 30 seconds the digital display on the control panel will switch off until such time as the refrigerator is used again. Error Codes In the event of an error occurring, the main control digital display screen will show one of the following codes: F1, F2, F3, F5, F6, Ed, ER, E0, E1, E2. If this happens, please contact Customer Service to have the refrigerator repaired. Door Ajar Alarm If any door is left open for more than 60 seconds the Door Ajar Alarm function will start.
3. Food Storage Tips Tips on Storing Fresh Food • Make sure that foods, which have been cooked and require chilling, are at room temperature before placing them into the appliance. Make sure that these foods are stored in suitable containers. • Melon, pineapples and bananas can go directly into the freezer after preparing, for storage over a longer period.
Tips on Freezing Food • As with storing fresh foods, suitable packaging, correct temperature and food hygiene will enhance the quality of the food you are freezing. • Avoid putting hot foods into the freezer. First let them cool until they reach room temperature. • Make sure that all foods for freezing are of a high quality, and suitable for freezing.
4. Installation Positioning Your Appliance Fig.4-1 Choosing the Right Location ArtNo.600-0034 - Clearances This appliance should be installed in a room that is dry and well ventilated. To ensure adequate ventilation, the refrigerator should be at least 15 mm clear on all sides from kitchen cabinetry (Fig.4-1). Any units placed above the appliance must be clear by 15mm to allow sufficient ventilation.
Refit the cable, pipe, door and top cover in the reverse sequence. Fig.4-7 When removing the hinge and separating it from the door body make sure to support the door to stop it falling forward. Removing the Upper Freezer Drawer Open the drawer as far as possible. Remove the ice tray and divider. Pull the rear section of the drawer inner compartment upwards slightly to enable the front section to be released from the door. ArtNo.
Water Supply Connection Fig.4-12ArtNo.600-0045 - Fitting the water pipe 1 ���������� It is recommended to have this product installed by a qualified technician. Cut the water pipe according to need and avoid bending the water pipe too much. Usually, the pipe length should be less than 5 m. If the water pipe is too long, the ice and cold water content will be affected because there may be insufficient water pressure.
5. Cleaning and Maintenance Defrosting Fig.5-1 Defrosting is done automatically so there is no need to manually defrost this appliance. DO NOT use mechanical devices to accelerate the defrosting process. Cleaning Disconnect the appliance from the power supply before cleaning. To keep internal odours to a minimum it is best to periodically clean the inside shelves, crispers, bins and wall. ArtNo.600-0028 - Replacing the filter 2 Empty the appliance of food and remove the shelves.
Changing the Water Filter Fig.5-2 Remove the old filter by turning the filter cartridge handle anti-clockwise (Fig.5-1). The cartridge will eject slightly from the filter housing (Fig.5-2). Air trapped in the system may cause water and the filter cartridge to eject. Use caution when removing. Pull out the cartridge from the filter housing. Note: Place a container under the filter housing to catch any water that may leak from the old filter cartridge. Unclip the filter handle from the cartridge (Fig.5-3).
When Not in Use Fig.5-6 If you are not using the appliance for an extended length of time, it is recommended that you switch off the electrical supply, empty any food out, clean the inside of the appliance and leave the door ajar. This will save energy, and also prevent a build up of stale odours inside. ���� Changing the Light Bulbs Before replacing the light bulb, switch off the electricity supply and unplug the refrigerator. • The electrical rating of the bulbs is 220~240V, 50Hz – 25W.
6. Troubleshooting Before calling for service, please first read the following table: this could save you time and money. Problem Cause Solution The temperature is too low The temperature inside the freezer is too low, with the fresh food temperatures fine. The temperature inside the fresh food compartment is too cold, while the freezer sections are fine. The foods stored in the full width pantry are frozen. 1.1.1 The temperature inside the freezer section is set too low. 1.1.1.1 1.2.
Problem Cause Solution 3.2 Water droplets collect in the lower crisper drawer areas. 3.2.1 Humidity settings are set too high. 3.2.1.1 3.3 Water forms at underside of the crisper glass covers. 3.3.1 Moisture given off from wet foods. 3.3.1.1 3.3.2 Door seal leaks or frequent door openings in humid environment. 3.3.2.1 It is normal for some wet air to collect inside the enclosed crisper.
Problem Cause Solution Cold water dispenser 6.1 6.2 6.3 Cold water not dispensing. The water has a strange odour. The water supply pressure is too low. 6.1.1 The water supply pipe is not open. 6.1.1.1 Open the water supply line all the way. 6.1.2 The water filter is blocked. 6.1.2.1 Replace the water filter. 6.1.3 The water line is blocked. 6.1.3.1 Check that the water tubes are not kinked or restricted. 6.2.1 The water has been stored too long without use. 6.2.1.
Problem Cause 9.2.3 9.2.4 9.2.5 9.2.6 Solution The doors or drawers are frequently opened and closed. The control settings in the freezer and fresh food compartments are set to cold level. Door and/or drawer gasket seals may be dirty, frayed or cracked. The condenser is dirty. 9.2.3.1 Try to reduce frequency of door or drawer openings. 9.2.4.1 Raise up the compartment temperatures slightly and allow 24 hours to reach new balance. 9.2.5.
7. Warranty/After Sales Service If consultation or technical assistance is needed, please provide the local authorised service agent with the purchase invoice and the product code/serial number. The product number/serial number is located inside the refrigerator on the top left-hand side. The 2 years free maintenance for the operation of the appliance started from the date of purchase of this product. Any cosmetic damage to the appliance must be reported within 90 days of delivery.
8. Technical Data DocNo.600-0008 - Technical data - DxD 910 INSTALLER: Please leave these instructions with the user. DATA BADGE LOCATION: Left-hand side of the refrigerator compartment. COUNTRY OF DESTINATION: GB/IE/BE/NL/DE/AT/CH/IT/SE Dimensions Depth with open door 1050 700 908 ArtNo.
DocNo.000-0001 - Back cover Rangemaster Clarence Street, Royal Leamington Spa, Warwickshire, CV31 2AD, England. Tel: +44 (0) 1926 457000 Fax: +44 (0) 1926 450526 E-mail: consumers@agarangemaster.co.uk ArtNo.
