RANGEMASTER REFRIGERATED WINE STORAGE UNIT Installation Operation and Maintenance Instructions Refrigerated Wine Storage Unit with Sentry System™ Refrigeration Monitor RWS38 RWS60DX RDZ60 Note: This appliance is intended to be used exclusively for the storage of wine.
TABLE OF CONTENTS Unpacking your wine storage unit...................................2 Removing the packaging.............................................2 Warranty Registration ..................................................2 Installing your wine storage unit......................................3 Selecting the location..................................................3 Cabinet Clearances ....................................................3 Leveling legs ................................................
UNPACKING YOUR WINE STORAGE UNIT Important Safety Instructions Warnings and safety instructions appearing in this guide are not meant to cover all possible conditions and situations that may occur. Common sense, caution, and care must be exercised when installing, maintaining, or operating this appliance. Recognize Safety Symbols, Words, and Labels. CAUTION-Hazards or unsafe practices which could result in personal injury or property or product damage.
INSTALLING YOUR WINE STORAGE UNIT Select Location The proper location will ensure peak performance of your appliance. We recommend a location where the unit will be out of direct sunlight and away from heat sources. To assure your product performs to specifications the recommended installation location temperature range is from 18 to 27°C for indoor built in units,18 to 32°C for indoor freestanding units.
ELECTRICAL CONNECTION Electrical Connection Use nominal 230 VAC, 50 Hz only. 13A must be used and fitted with a 13A fuse “ASTA” approved to BS 1363. Do not use an extension cord with this appliance. If you replace the fuse, the cover must be refitted. If the cover is lost, the plug must not be used until a replacement has been obtained from your supplier. The color of the fuse cover is that of the insert in the base of the fuse recess or elsewhere on the plug.
USING YOUR Sentry System™ CONTROL, MODELS RWS38 & RWS60DX LED ON OFF 13 C Set Warmer °F/C Colder Light Sentry System™ Power Failure - Flashing Amber High/Low Temp - Red Press ON/OFF - Reset Alarms OFF - Steady Amber Figure 3 Press and Hold Start Your Appliance Please observe the following options when starting your appliance during initial plug-in. 1) If Sentry System™ LED is flashing amber (see Figure 3) the appliance is on. Simply press and release “ON/ OFF” button to stop the flashing LED.
USING YOUR Sentry System™ CONTROL MODEL RDZ60 Lower Upper ON OFF Sentry System ™ Warmer ˚F/C Colder Light SET Press and Hold Start Your Appliance Please observe the following options when starting your appliance during initial plug-in. 1) If Sentry System™ LED is flashing amber (see Figure 4) the appliance is on. Simply press and release “ON/ OFF” button to stop the flashing LED.
DIMENSIONS FOR RWS38 INSTALLER: Please leave these instructions with the user. DATA BADGE LOCATION: Front left-hand side of the refrigerator compartment.
DIMENSIONS FOR RWS60DX INSTALLER: Please leave these instructions with the user. DATA BADGE LOCATION: Front left-hand side of the refrigerator compartment. COUNTRY OF DESTINATION: GB/IE 1179mm 651mm Ratings 648mm 607mm 599mm Electrical-voltage/frequency Energy efficiency class on a scale of A (more efficient) to G (less efficient) B Climate class (SN=10-32°C, T N=16-32°C, ST=18-38°C, T=18-43°C Temperature range 857 to 883mm (from > to) 4.4 to 18.
DIMENSIONS FOR RDZ60 1168mm INSTALLER: Please leave these instructions with the user. DATA BADGE LOCATION: Front left-hand side of the refrigerator compartment. COUNTRY OF DESTINATION: GB/IE 651mm Ratings 607mm 636mm Electrical-voltage/frequency Energy efficiency class on a scale of A (more efficient) to G (less efficient) B Climate class (SN=10-32°C, ST N=16-32°C, ST=18-38°C, T=18-43°C Temperature range 861 to 886mm 220-240 V / 50Hz (from > to) 4.4 to 18.
FEATURES FOR MODEL RWS38 Insert Wine Bottles The six (6) roll-out shelves each hold four (4) bottles. See Figure 5 for typical wine bottle spacing. Tall bottles should not be loaded on the bottom rack because they may prevent the door from closing. Front Bottles (Necks Facing Rear) Rear Bottles (Necks Facing Front) Loading Tips and Suggestions Position white wines on the middle or lower racks and red wines on the upper racks (see Figure 6).
FEATURES FOR MODEL RWS60DX Insert Wine Bottles The six (6) roll-out shelves each hold eight (8) bottles. See Figure 8 for typical wine bottle spacing. Tall bottles should not be loaded on the bottom rack because they may prevent the door from closing. Front Bottles (Necks Facing Rear) Rear Bottles (Necks Facing Front) Loading Tips and Suggestions Position white wines on the middle or lower racks and red wines on the upper racks (see Figure 9).
FEATURES FOR MODEL RDZ60 Independent Storage Compartments Both compartments can be set for either temperature range, red or white, but for a more efficient energy usage and functionality of the unit, it is better to use the top compartment for reds (warmer) and the bottom compartment for whites (cooler). Front Bottles (Necks Facing Rear) Rear Bottles (Necks Facing Front) Insert Wine Bottles The five (5) upper shelves each hold eight (8) bottles in a front to back fashion.
CARE AND CLEANING Condenser The condenser underneath the cabinet does not require frequent cleaning; however, satisfactory cooling depends on adequate ventilation over this heat exchanger. It is recommended to annually clean the condenser by vacuuming and brushing. To access the condenser, the unit must be pulled out from the installation, and the lower machine compartment access cover removed. Disconnect the power cord before removing the access cover.
CARE AND CLEANING Light Tube Replacement two screws to secure it in place. Plug the wine storage unit into the electrical socket. Check to see if the light tube operates properly. Your light tube’s replacement is complete. DISCONNECT THE POWER CORD BEFORE ATTEMPTING LIGHT TUBE REPLACEMENT. Failure to do so may result in an electrical shock that could severely injure you.
CARE AND CLEANING Door alignment The door should be parallel to the sides and top of the refrigerator. If alignment is necessary the door may be adjusted by loosening the 2 screws which secure the hinge adapter brackets to the door and adjusting the door side to side. Use a 5/32” hex key for this procedure. (See Figure 15 below). Hinge adapter screws loosen these to adjust door, on the top and bottom of the door. Remove the top hinge pin to remove the door. 7.
ENERGY SAVING TIPS Energy Saving Tips The following suggestions will minimize the cost of operating your refrigeration appliance. 1. Do not install your appliance next to a hot appliance, (cooker, dishwasher, etc.). heating air duct, or other heat sources. 2. Install product out of direct sunlight. 3. Assure the toe grille vents at front of unit beneath door is not obstructed and kept clean to allow ventilation for the refrigeration system to expel heat. 4.
TROUBLESHOOTING YOUR WINE STORAGE UNIT Before You Call for Service If the unit appears to be malfunctioning, read through this manual first. If the problem persists, check the troubleshooting guide below. Locate the problem in the guide and refer to the cause and its remedy before calling for service. The problem may be something very simple that can be solved without a service call. Some remedies listed in the Troubleshooting Guide are very complex.
OBTAINING SERVICE AND GUARANTEE How to Obtain Service In the unlikely event that you have a problem with your wine storage unit, please refer to your User’s Documentation first to check that you are using the unit correctly. If you are still having difficulty, you can ring our Consumer Services Centre on the number below, where one of our coordinators will be pleased to advise you.
Clarence Street, Royal Leamington Spa, Warwickshire, CV31 2AD, England. Tel: +44 (0) 1926 457400 Fax: +44 (0) 1926 450526 E-mail: consumers@rangemaster.co.uk www.rangemaster.co.uk 41011814 Rev F 6/3/13 All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.
