User's Manual

Page 15
Depending on the DC input voltage and the temperature, a complete
process will demand between 3 and 4 hours. If the radio is on during the
charging process, the time will extend, depending on the radio activity.
Installing/ Removing the LI-Ion Battery Pack
Only use the ST-SBP18 or ST-BP18 battery packs with this transceiver.
1- Match the grooves of the battery pack with the
corresponding guides on the back of the transceiver.
2- Slide the battery pack along the back of the transceiver until
the release latch on the base of the transceiver locks.
3- To remove the battery pack, pull off the battery lock and slide
down the pack away from the transceiver.
Installing the Antenna ST-FA0X
Screw the antenna into the connector on the top of the transceiver by
holding the antenna at its base and turning it clockwise until secure.
Installing the Belt Clip
If desired, attach the belt clip using the two supplied screws.