User's Manual

SDRe Programming Software
Revision V1.0
P a g e | 24
If your repeater model is not in your list, please update your
software.
If you are not sure about your model info, you can read the repeater
by pressing the read button on the quick access bar once your
repeater is connected through the Ethernet port or USB cable with
the computer where the SDRe programming software is running.
Model info is also into the serial number label in the backside of
your repeater.
Once the model is selected, the correct frequency range, max power
and accessories are enabled into the model info screen.
Model: is the general model of the radio family.
Internal Code: is a production code assigned to the repeater into
the manufacturing process.
Radio Type: is the type of device.
Min Freq: Refer to the lowest operational frequency, which can be
programmed into your repeater.
Max Freq: Refer to the lowest operational frequency, which can be
programmed into your repeater.
Maximum Power: Is the maximum power supported by your RF
TX configuration. It may be different, depending on the region.
Display: Shows the type of display of the repeater
Once selected the right model press [OK] to accept it.
4.2. Repeater Buttons Definition
Before using the repeater, you must assign the functionality of each
one of the repeater buttons.
Please click on [Edit] then [Buttons] to access to the buttons
definition screen.
It is important to keep your software updated to ensure any SDRe repeater is into the model info list. If
your model is not into the current list, please update your repeater
Note: 5 - Incomplete model info list requires software update