User's Manual

SDRe Programming Software
Revision V1.0
P a g e | 55
To store this option, click on any part of the tab. To save the value,
press [Ok] or Cancel if you want to discard the changes.
4.6.1.7. Setup the repeater tail
Fill this field with the length desired for repeater tail. 0 second means
no tail. Max value is 255 seconds.
Figure 60: Repeater tail setup
To store the value, click on any part of the tab. To save the value,
press [Ok] or Cancel if you want to discard the changes.
4.6.1.8. Enable the Roaming Service on Analog Profiles
If you want set a limit of minutes for a call length, then fill this field.
0 minute means no limit. Absolute Max call length is 255 minutes.
Figure 61: Repeater MAX Call Length
To store the value, click on any part of the tab. To save the value,
press [Ok] or Cancel if you want to discard the changes.
4.6.1.9. Repeater Penalty setup
If call length limit is reached, the repeater may apply a penalty for
the CTCSS tone (group) who has reached the limit.
For example, if a particular group, who uses one of the tones defined
on the CTCSS table, reaches the max length accepted for this profile,
that tone remains inactive by the amount of seconds defined on this
step.