User's Manual

SDRe Programming Software
Revision V1.0
P a g e | 71
6. Reading the Repeater programming from the device
All the information already downloaded to your radio can be retrieved
anytime.
In case that information has been protected by password, you must
know such critical information to start the reading process.
To read the radio file from the repeater, you must connect the radio to
the USB port on your computer or by IP, as previously defined on the
Programming Software configuration (see 2.2.1), then you can use the
shortcut in the quick access bar or you go through [Repeater] then
click on Read Repeater. F2 key on your computer keyboard can be used
as a shortcut also.
Figure 90: Accessing to read the repeater
Once you press on [Read Repeater], the information stored in the device
will be loaded to your programming software automatically.
As soon as the process starts, a progress bar will show you the process
evolution.
When you download a Repeater file from the Repeater, previous information into your programming
software will be overwritten. Please ensure you have already saved that information before proceed to
download from the repeater
Note: 12- Downloading the repeater fill will overwrite existing information in Programming Software