Owner manual

9060 Cascade Low Voltage Controller - Installation
25 CP-13-02.2
 If a different switch is being used for the
trigger signal, read the switch documenta-
tion for the wiring instructions for the spe-
cific switching element. Verify whether
sinking or sourcing is to be used so the
local/remote trigger protection board
jumpers are set correctly. For further in-
formation, consult your authorized
Ransburg distributor for specific directions
pertaining to your installation or call Cus-
tomer Service.
N O T E
4. The local/remote board (Assy# A13123),
shown in Figure 14 at the bottom below the
remote I/O signal terminal block, is de-
signed for trigger protection in REMOTE
mode. It must have the jumpers adjusted
into “bypass position” to allow for LOCAL
mode operation for the desired input type.
The location of the jumpers on the board is
displayed in Figure 16. Use the LOCAL
mode jumper settings table for the jumper
settings based upon your specific input.
Figure 14: Remote I/O Signal Terminal Block
Trigger Signal -
Position 5
In TB2
Jumper
Local Source Local Sink
JMP1 1-3 1-3
JMP1 2-4 4-6
JMP2 2-3 1-2
LOCAL Mode Jumper Settings


 The 9060 Cascade Low Voltage Con-
troller is designed to handle both a sinking
or sourcing trigger input.
 DO NOT use a sourcing trigger signal
with the 9060 jumpers set for sinking in-
puts or vice versa. Sourcing and sinking
inputs have different current flow paths.
Using the wrong settings for the wrong
type input can have unexpected behavior
and/or cause damage to the input circuits.
!
W A R N I N G
Figure 13: Ground Screw on Base Plate
 The standard air flow switch (13742-01
or 13742-02) used in the 9060 is wired as
a sinking switch. When the flow switch is
activated, it connects the trigger signal
input to ground. This requires that the
local/remote trigger protection board be
setup to accept a sinking input. If sourc-
ing inputs are needed, the flow switch
ground wire must be changed to a 24V
DC connection (available on the terminal
blocks).
N O T E
Back of Cabinet
Ground Screw