SERVO FEED OPERATING INSTRUCTIONS Models CJ series (5-07) 104 & 108 CJ (not available after 5-07) 106 & 112 CJ (available after 5-07) Rapid-air corporation 4601 Kishwaukee St. • Rockford, IL 61109-2925 Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.
table of contents introduction........................................................................................................................................... pg. 3 installation, mechanical & Electric pilot release.............................................................. pg. 4 Programming procedure.................................................................................................................. pg. 5-6 Fatal fault error codes...................................................
introduction The CJ Servo The CJ servo has many features found in the more expensive models. Some of it’s features are: Input: 120 VAC, 50/60 HZ . Amperage required at input: 10 amps maximum. . Accuracy: .0025 per feed length at the rolls. . Maximum feed length input: 999.999 inches. . Job storage: 99 jobs . Display: 4 rows by 80 characters, backlit Fault type: Displayed on the drive if a fault occurs otherwise an “8.” is displayed. . Rolls: Hardened and Ground. .
installation, mechanical & Electric pilot Release Installation The Rapid-Air servo was run and fully tested before being shipped from our plant. Carefully inspect all parts when uncrating them. If you find any damaged parts, please report it to the carrier that delivered the servo drive and at the same time, report the damage to your distributor.
Programming procedure Operator Input Section The intent of this section is to familiarize the operator with the flow of the program and what to expect with each key press. Each program screen of the servo will be displayed and also comments to clarify possible questions.
programming procedure (continued) Operator Input Section caution as all the jobs being used will reset to the default parameters and cannot be restored without keying each job number’s parameters. The following screen is displayed when the period is pressed while the “Main Selection menu” is displayed. RESET JOB PARAMETERS TO DEFAULT VALUE F1=RESET VALUES F4=RETURN-DON’T RESET It is very important that the operator make a hard copy of the jobs on a sheet of paper so there is a permanent record.
No message faults 7.3.
104 CJ Servo Feed
106 & 112 CJ Servo Feeds
10 104 & 108 CJ Servo Feeds
11 106 & 112 CJ Mechanical Pilot Actuating Arm
12 Keypad
13 CJ Wiring Schematic
14 S.P.M.
15 ServoStar Drive
16 SservoStar Drive (C2)
