Install Manual
FastPipe Cooling Loop Installation Instructions
A filter regulator unit is recommended to keep contaminants out of the air
system and to allow for pressure adjustment.
PRESSURE RATINGS
The FastPipe system has a maximum working pressure of 190 psi and
a temperature range from 0 to 140 deg F.
ASSEMBLY OF THREADED COMPONENTS
Assemble all NPT threads with two wraps of teflon tape and then PIPE
SEALANT which prevents thread galling.
IF YOU ARE EXPERIENCING TROUBLE WITH THIS PRODUCT, OR
MISSING PARTS, PLEASE CALL 800-954-33
10 FOR ASSISTANCE
DO NOT RETURN TO STORE
ASSEMBLY INSTRUCTIONS
1.) Locate a flat, empty wall near an air compressor
2.) Cut an 8 inch piece out of all four long tubes with an approved cutter
3.) Install ball valves into tees--see note below on thread prep procedure
4.) Assemble black wall outlet into last tee
5.) Debur pipe ends
6.) Hang the piping, installing the top clips just below the elbows to prevent
the assembly from sliding downward
AIR COMPRESSOR
Use a flexible jumper hose from the air compressor to reduce vibration to
the FastPipe System.
INSTALLATION
FILTER REGULATOR