How To Guide

Qty. Inside Corners _________
(determine number of
inside corners)
Qty. Outside Corners _________
(determine number of
outside corners)
Qty. Middle Blocks _________
(used between two pieces of
RapidFit
®
base moulding)
1.
Measure the total distance around all windows and doors. Compute how many feet of casing are needed to complete your project.
Remember to add sufcient material to cover trim and waste (10% over is typically sufcient).
Windows and Doors: Total Inches _________ " / 12" = Total Feet _________ '
8' Casing Qty. _________ 12' Casing Qty. _________
2. Rosettes: Used at door and window corners. The number of Rosettes needed to complete
your job will depend on the number of doorways and windows you are updating. Consider
the illustration to the right when determining how many Rosettes you will need.
Total Rosette Qty. for Windows and Doors _________
3. Plinth Blocks: Plinth Blocks are used at the bottom of door casing, where base moulding meets door casing. Single Carved Plinth
Blocks are to be used when upgrading your casing ONLY. Dual Carved Plinth Blocks are used when upgrading BOTH casing and base.
4. Spacers: Spacers act as a buffer between the heel of your old casing and RapidFit casing. Place Spacers every 6 inches.
Each spacer is 1/8" thick and can be stacked on top of each other to ll in any gap.
Total Project Inches _________ / 6 in. = _________ of spacers needed / 50 per pack = _________ packages
1. Measure the total distance around your room, excluding openings for doors. Remember
to add sufcient material to cover trim and waste (10% over is typically sufcient).
Room Measurements: Total Inches _________ " / 12" = Total Feet _________ '
8' Base Qty. _________ 12' Base Qty. _________
2. Transition Blocks: Transition Blocks are used to create a smooth transition between existing door casing applications and your newly upgraded base.
Transition Blocks are packaged in pairs, one for each side of the door opening. They are not necessary if you are upgrading both casing and base.
_________ x 1 set Transition Blocks
3.
4. Spacers: Spacers act as a buffer between the face of your old base and RapidFit base. Place Spacers every 6 inches.
Each spacer is 1/8” thick and can be stacked on top of each other to ll in any gap.
Total Project Inches _________ / 6 in. = _________ of spacers needed / 50 per pack = _________ packages
1. Measure the total distance around your room. Remember to add sufcient material to cover trim and
waste (10% over is typically sufcient).
Room Measurements: Total Inches _________ " / 12" = Total Feet _________ '
8' Crown Qty. _________ 12' Crown Qty. _________
2.
Check List
Block Installation
Number of Doors _________ x 1 set
Single Carved Plinth Block
Number of Doors _________ x 1 set
Dual Carved Plinth Block
or
CasingBaseCrown
4 corners
requires
4 rosettes
2 corners
requires
2 rosettes
Optional
plinth blocks
Qty. Inside Corners _________
(determine number of
inside corners)
Qty. Outside Corners _________
(determine number of
outside corners)
Qty. Middle Blocks _________
(used between two pieces of
RapidFit
®
crown moulding)
Floor Plan
Inside Corner Blocks
Outside
Corner Blocks