Installation Manual

6. Fasten the Step Bar to the Front and Rear
Brackets using one (1) M14 x 60MM Bolt, one
(1) M14 Lock Washer and one (1) M14 Flat
Washer per bracket.
Place rubber gasket on center cradle.
3
Rev 5
0103-0767
M14 X 60MM
HEX HEAD BOLT
M14 LOCK
WASHER
M14 FLAT
WASHER
3” ROUND TUBE
Front
Underside of Truck
7
Front
Underside of Truck
7. Fasten center bracket
using one (1) M10 x 30MM
Button Head Bolt, one (1)
M10 Lock Washer and one
(1) M10 Flat Washer.
Tighten until the split lock
washer is flat against brack-
et and snug. DO NOT over
tighten and strip the
threaded insert in the tube.
Repeat these steps for
passenger side installation.
When all hardware is in
place, everything must be
tightened. See Page 1 for
Torque Specifications.
M10 x 30MM
BUTTON
HEAD BOLT
M10 LOCK
WASHER
M10 FLAT
WASHER
RUBBER
GASKET
6