Installation Manual

1
0402-0130, 0402-0130B
4” OVAL BAR WHEEL TO WHEEL
0402-0130, 0402-0130B
Rev 6
1. Remove all contents from the package and check
stainless steel tubes for any damage. Also, verify that all
components and hardware listed above are included
before you begin installation.
2. Read installation manual and installation drawing
completely. Understand all brackets and bolts before
installation.
3. Begin installation on the driver’s side. Remove the
body mount bolts from the front and rear body mounts
underneath cab of truck and discard. (Keep the bushings).
Align Front and Rear Bracket as shown.
Driver Side
Components:
Driver Side
Step Bar
Qty 1
Passenger Side
Step Bar
Qty 1
Front Bracket
Qty 2
Rear Bracket
Qty 2
Front Support
Braces
Qty 2
Rear Support
Braces
Qty 2
M10 Bolt
Plate
Qty 4
Rubber
Gasket
Qty 4
Hardware:
Cab Mount
Bolt
Qty 4
M12 Rubber
Washer
Qty 4
M10 x 30mm
Hex Head Bolt
Qty 4
M10 Flat
Washers
Qty 20
Plastic
Push Nut
Qty 4
M10 Lock
Washers
Qty 16
M8 Bolt
Plate
Qty 2
M8 Flat
Washer
Qty 2
M8 Lock
Washer
Qty 2
M8 Flange
Lock Nut
Qty 2
M8 Retainer
Qty 2
Torque Specifications:
For Cab Mount Installations
Cab Mount bolts are torqued to 70 Ft Lbs. All other M8 through M12 sized bolts/nuts are set to 15-20 ft lbs.
Tools Required:
Note: When installing the brackets and bars, all hardware must be left loose until all the items are attached.
17MM SOCKET
RATCHET
TORQUE
WRENCH
19MM SOCKET
M10 Hex
Head Nuts
Qty 8
M10 x 30 mm
Button Head
Bolts
Qty 8
13MM HEX BIT 6MM HEX BIT