Owner's manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Accessing CC-SG
- Chapter 3: Configuring CC-SG with Guided Setup
- Chapter 4: Creating Associations
- Chapter 5: Adding Devices and Device Groups
- Chapter 6: Configuring Nodes and Interfaces
- Chapter 7: Adding and Managing Users and User Groups
- Chapter 8: Policies
- Chapter 9: Configuring Remote Authentication
- Chapter 10: Generating Reports
- Audit Trail Report
- Error Log Report
- Access Report
- Availability Report
- Active Users Report
- Locked Out Users Report
- User Data Report
- Users in Groups Report
- Group Data Report
- AD User Group Report
- Asset Management Report
- Node Asset Report
- Active Nodes Report
- Node Creation Report
- Query Port Report
- Active Ports Report
- Scheduled Reports
- CC-NOC Synchronization Report
- Chapter 11: System Maintenance
- Chapter 12: Advanced Administration
- Appendix A: Specifications (G1, V1, and E1)
- Appendix B: CC-SG and Network Configuration
- Appendix C: User Group Privileges
- Appendix D: SNMP Traps
- Appendix E: Troubleshooting
- Appendix F: Two-Factor Authentication
- Appendix G: FAQs
- Appendix H: Keyboard Shortcuts

CHAPTER 10: GENERATING REPORTS 119
Chapter 10: Generating Reports
Reports can be sorted by clicking on the column headers. Click a column header to sort report
data by the values in that column. The data will refresh in ascending order alphabetically,
numerically, or chronologically. Click the column header again to sort in descending order.
You can resize the column width in all reports. Hold your mouse pointer on the column divider in
the header row until the pointer becomes a double-headed arrow. Click and drag the arrow to the
left or right to adjust column width.
The sorting value and column width you use becomes the default report view the next time you
log in and run CC-SG reports. For all reports, you can double-click a row to view further details
of the report.
Note: In all reports, use CTRL+click to deselect a highlighted row.
Audit Trail Report
The Audit Trail report displays audit logs and access in CC-SG. It captures actions such as
adding, editing, or deleting devices or ports, and other modifications.
CC-SG maintains an Audit Trail of the following events:
• When CC-SG is launched
• When CC-SG is stopped
• When a user logs on CC-SG
• When a user logs off CC-SG
• When a user starts a node connection
1. On the Reports menu, click Audit Trail. The Audit Trail screen appears.
Figure 112 Audit Trail Screen
2. Set the date range for the report in the Start Date and End Date fields. Click each
component of the default date (month, day, year, hour, minute, second) to select it, and then
click the up and down arrows to reach the desired number.
3. You can limit the data that the report will contain by entering additional parameters in the
Message, Username, and User IP address fields.
• If you want to limit the report by the message text associated with an activity, type the text in
the Message field.
• If you want to limit the report to a particular user’s activities, type the user’s username in the
Username field.
• If you want to limit the report to a particular IP address’s activities, type the user’s IP address
in the User IP address field.