Owner's manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Accessing CC-SG
- Chapter 3: Configuring CC-SG with Guided Setup
- Chapter 4: Creating Associations
- Chapter 5: Adding Devices and Device Groups
- Chapter 6: Configuring Nodes and Interfaces
- Chapter 7: Adding and Managing Users and User Groups
- Chapter 8: Policies
- Chapter 9: Configuring Remote Authentication
- Chapter 10: Generating Reports
- Audit Trail Report
- Error Log Report
- Access Report
- Availability Report
- Active Users Report
- Locked Out Users Report
- User Data Report
- Users in Groups Report
- Group Data Report
- AD User Group Report
- Asset Management Report
- Node Asset Report
- Active Nodes Report
- Node Creation Report
- Query Port Report
- Active Ports Report
- Scheduled Reports
- CC-NOC Synchronization Report
- Chapter 11: System Maintenance
- Chapter 12: Advanced Administration
- Appendix A: Specifications (G1, V1, and E1)
- Appendix B: CC-SG and Network Configuration
- Appendix C: User Group Privileges
- Appendix D: SNMP Traps
- Appendix E: Troubleshooting
- Appendix F: Two-Factor Authentication
- Appendix G: FAQs
- Appendix H: Keyboard Shortcuts

130 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE
records. Click Print to print the records that are displayed in the current report page or Print
All to print all records. Click Close to close the window.
• Click Refresh to generate a new report. The report may take several minutes to generate,
based on the size of your system configuration.
• Click Close to close the report.
Node Asset Report
The Node Asset report displays node name, interface name and type, device name and type, and
node group for all nodes under CC-SG management. You can also filter the report to include only
data about nodes that correspond to a specified node group, interface type, device type, or device.
1. On the Reports menu, click Nodes, and then click Node Asset Report. The Node Asset
Report screen displays.
Figure 126 Node Asset Report Screen
2. Click the radio button that corresponds to the filtering criteria you want to apply to the report,
All Nodes, Node Group, Device Group, or Devices.
• If you selected Node Group, Interface Type or Device Group, click the corresponding
drop-down arrow, and then select a parameter from the list.
• If you selected Devices, select the devices in the Available list whose node assets you
want to include in the report, and then click Add to move them to the Selected list.