Owner's manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Accessing CC-SG
- Chapter 3: Configuring CC-SG with Guided Setup
- Chapter 4: Creating Associations
- Chapter 5: Adding Devices and Device Groups
- Chapter 6: Configuring Nodes and Interfaces
- Chapter 7: Adding and Managing Users and User Groups
- Chapter 8: Policies
- Chapter 9: Configuring Remote Authentication
- Chapter 10: Generating Reports
- Audit Trail Report
- Error Log Report
- Access Report
- Availability Report
- Active Users Report
- Locked Out Users Report
- User Data Report
- Users in Groups Report
- Group Data Report
- AD User Group Report
- Asset Management Report
- Node Asset Report
- Active Nodes Report
- Node Creation Report
- Query Port Report
- Active Ports Report
- Scheduled Reports
- CC-NOC Synchronization Report
- Chapter 11: System Maintenance
- Chapter 12: Advanced Administration
- Appendix A: Specifications (G1, V1, and E1)
- Appendix B: CC-SG and Network Configuration
- Appendix C: User Group Privileges
- Appendix D: SNMP Traps
- Appendix E: Troubleshooting
- Appendix F: Two-Factor Authentication
- Appendix G: FAQs
- Appendix H: Keyboard Shortcuts

158 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE
3. Under Network Tasks in the Network Connections window, click Create a new
connection.
Figure 160 Create a New Connection
4. Click Next, Connect to the network at my workplace, Dial-up connection.
5. Type a name for CC-SG, for example CommandCenter.
Figure 161 Connection Name
6. Type the phone number used to connect to CC-SG, and then click Next. This is NOT the dial-
back number that was configured as the Client phone under the Modem tab in
Configuration Manager on CC-SG.
Figure 162 Phone Number to Dial
7. A smart card is not necessary to dial into CC-SG. If you are not using one, click Do not use
my smart card for this connection, and then click Next.
8. In the next screen, typically click My use only in the next screen to make the connection
available only to yourself.
9. Click Finish in the last screen to save the connection settings.