Owner's manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Accessing CC-SG
- Chapter 3: Configuring CC-SG with Guided Setup
- Chapter 4: Creating Associations
- Chapter 5: Adding Devices and Device Groups
- Chapter 6: Configuring Nodes and Interfaces
- Chapter 7: Adding and Managing Users and User Groups
- Chapter 8: Policies
- Chapter 9: Configuring Remote Authentication
- Chapter 10: Generating Reports
- Audit Trail Report
- Error Log Report
- Access Report
- Availability Report
- Active Users Report
- Locked Out Users Report
- User Data Report
- Users in Groups Report
- Group Data Report
- AD User Group Report
- Asset Management Report
- Node Asset Report
- Active Nodes Report
- Node Creation Report
- Query Port Report
- Active Ports Report
- Scheduled Reports
- CC-NOC Synchronization Report
- Chapter 11: System Maintenance
- Chapter 12: Advanced Administration
- Appendix A: Specifications (G1, V1, and E1)
- Appendix B: CC-SG and Network Configuration
- Appendix C: User Group Privileges
- Appendix D: SNMP Traps
- Appendix E: Troubleshooting
- Appendix F: Two-Factor Authentication
- Appendix G: FAQs
- Appendix H: Keyboard Shortcuts

168 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE
Recover a Failed CC-SG Node
When a node fails and failover occurs, the failed node will recover in Waiting status.
1. Select the Waiting node in the Cluster Configuration table.
2. Add it as a backup node by clicking Join “Waiting” Node.
3. A confirmation message will appear. Click Yes to assign Secondary status to the selected
node, or click No to cancel. If you click Yes, you will need to wait for the secondary node to
restart just as with Join “Backup” Node.
Note: Once a node is in Waiting status it can be started in Standalone mode or Backup mode.
Set Advanced Settings
To configure advanced settings of a cluster configuration:
1. Select the Primary node just created.
2. Click Advanced. The Advanced Settings window appears.
Figure 172 Cluster Configuration Advanced Settings
3. For Time Interval, enter how often CC-SG should check its connection with the other node.
Note: Setting a low Time Interval will increase the network traffic generated by heartbeat checks.
Also, clusters with nodes located far apart from each other may want to set higher intervals.
4. For Failure Threshold, enter the number of consecutive heartbeats that must pass without a
response before a CC-SG node is considered failed.
5. For Recover After, enter the number of consecutive heartbeats that must successfully be
returned before a failed connection is considered recovered.
6. Click OK to save the settings.
Note: Changing the time zone is disabled in a cluster configuration.