Owner's manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Accessing CC-SG
- Chapter 3: Configuring CC-SG with Guided Setup
- Chapter 4: Creating Associations
- Chapter 5: Adding Devices and Device Groups
- Chapter 6: Configuring Nodes and Interfaces
- Chapter 7: Adding and Managing Users and User Groups
- Chapter 8: Policies
- Chapter 9: Configuring Remote Authentication
- Chapter 10: Generating Reports
- Audit Trail Report
- Error Log Report
- Access Report
- Availability Report
- Active Users Report
- Locked Out Users Report
- User Data Report
- Users in Groups Report
- Group Data Report
- AD User Group Report
- Asset Management Report
- Node Asset Report
- Active Nodes Report
- Node Creation Report
- Query Port Report
- Active Ports Report
- Scheduled Reports
- CC-NOC Synchronization Report
- Chapter 11: System Maintenance
- Chapter 12: Advanced Administration
- Appendix A: Specifications (G1, V1, and E1)
- Appendix B: CC-SG and Network Configuration
- Appendix C: User Group Privileges
- Appendix D: SNMP Traps
- Appendix E: Troubleshooting
- Appendix F: Two-Factor Authentication
- Appendix G: FAQs
- Appendix H: Keyboard Shortcuts

186 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE
SSH Commands
The following table describes all commands available in SSH. You must be assigned the
appropriate privileges in CC-SG to access each command.
COMMAND
DESCRIPTION
activeports
List active ports.
activeusers
List active users.
backup device <[-host <host>] | [-id <device_id>]> backup_name [description]
Backup device configuration.
clear
Clear screen.
connect [-d <device_name>] [-e <escape_char>] <[-i <interface_id>] | [-
n
<port_name>] | [port_id]>
Establish a connection to a serial port. If <port_name> or <device_name> contains spaces it
should be surrounded by quotes.
copydevice <[-b <backup_id>] | [source_device_host]> target_device_host
Copy device configuration
disconnect <[-u <username>] [-p <port_id>] [-id <connection_id>]>
Close port connection.
entermaint minutes [message]
Place CC-SG in maintenance mode.
exitmaint
Remove CommandCenter from maintenance mode.
grep search_term
Search text from piped output stream.
help
View help screen.
listbackups <[-id <device_id>] | [host]>
List available device configuration backups.
listdevices
List available devices.
listfirmwares [[-id <device_id>] | [host]]
List firmware versions available for upgrade.
listinterfaces [-id <node_id>]
List all interfaces.
listnodes
List all nodes.
listports [[-id <device_id>] | [host]]
List all ports.
logoff [-u <username>] message
Logoff user
ls
List commands