Owner's manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Accessing CC-SG
- Chapter 3: Configuring CC-SG with Guided Setup
- Chapter 4: Creating Associations
- Chapter 5: Adding Devices and Device Groups
- Chapter 6: Configuring Nodes and Interfaces
- Chapter 7: Adding and Managing Users and User Groups
- Chapter 8: Policies
- Chapter 9: Configuring Remote Authentication
- Chapter 10: Generating Reports
- Audit Trail Report
- Error Log Report
- Access Report
- Availability Report
- Active Users Report
- Locked Out Users Report
- User Data Report
- Users in Groups Report
- Group Data Report
- AD User Group Report
- Asset Management Report
- Node Asset Report
- Active Nodes Report
- Node Creation Report
- Query Port Report
- Active Ports Report
- Scheduled Reports
- CC-NOC Synchronization Report
- Chapter 11: System Maintenance
- Chapter 12: Advanced Administration
- Appendix A: Specifications (G1, V1, and E1)
- Appendix B: CC-SG and Network Configuration
- Appendix C: User Group Privileges
- Appendix D: SNMP Traps
- Appendix E: Troubleshooting
- Appendix F: Two-Factor Authentication
- Appendix G: FAQs
- Appendix H: Keyboard Shortcuts

206 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE
Diagnostic Console Passwords (Admin)
This option provides the ability to configure the strength of passwords (status and admin) and
allows you to configure password attributes, such as, the setting maximum number of days that
must lapse before you need to change the password, which should be done via the Account
Configuration menu. The operation in these menus only applies to Diagnostic Console accounts
(status and admin) and passwords – it has no effect on the regular CC-SG GUI accounts or
passwords.
Password Configuration
1. Click Operation, Admin, DiagCon Passwords, and then click Password Configuration.
2. In the Password History Depth field, type the number of passwords that will be remembered.
The default setting is 5.
Figure 208 Configuring Password Settings