Owner's manual

18 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE
20. If you want the Element to apply to the device and to the nodes connected to the device,
check the Apply to Nodes checkbox.
21. If you want to add another device, click Apply to save this device, and then repeat the steps
in this section to add additional devices.
22. When you have finished adding devices, click OK. The Device Summary panel displays a
list of the devices that you added.
23. Click Continue to start the next task, Create Groups. Follow the steps in the next section.
Create Groups
The third task of Guided Setup is Create Groups. Create Groups allows you to define groups of
devices and groups of nodes and specify the set of devices or nodes included in each group.
Administrators can save time by managing groups of similar devices and nodes, rather than
managing each device or node individually.
Add Device Groups and Node Groups
1. The Devices Groups Manager panel opens when you click Continue at the end of the
Device Setup task. You can also click Create Groups, and then click Add Devices Groups
in the Guided Tasks tree view in the left panel to open the Devices Groups Manager panel.
2. In the Group name field, type a name for a device group you want to create.
3. There are two ways to add devices to a group, Select Devices and Describe Devices. The
Select Devices tab allows you to select which devices you want to assign to the group by
selecting them from the list of available devices. The Describe Devices tab allows you to
specify rules that describe devices, and the devices whose parameters follow those rules will
be added to the group.
Select Devices
a. Click the Select Devices tab in the Add Devices Groups panel.
Figure 14 Guided Setup—Add Device Groups, Select Devices