Owner's manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Accessing CC-SG
- Chapter 3: Configuring CC-SG with Guided Setup
- Chapter 4: Creating Associations
- Chapter 5: Adding Devices and Device Groups
- Chapter 6: Configuring Nodes and Interfaces
- Chapter 7: Adding and Managing Users and User Groups
- Chapter 8: Policies
- Chapter 9: Configuring Remote Authentication
- Chapter 10: Generating Reports
- Audit Trail Report
- Error Log Report
- Access Report
- Availability Report
- Active Users Report
- Locked Out Users Report
- User Data Report
- Users in Groups Report
- Group Data Report
- AD User Group Report
- Asset Management Report
- Node Asset Report
- Active Nodes Report
- Node Creation Report
- Query Port Report
- Active Ports Report
- Scheduled Reports
- CC-NOC Synchronization Report
- Chapter 11: System Maintenance
- Chapter 12: Advanced Administration
- Appendix A: Specifications (G1, V1, and E1)
- Appendix B: CC-SG and Network Configuration
- Appendix C: User Group Privileges
- Appendix D: SNMP Traps
- Appendix E: Troubleshooting
- Appendix F: Two-Factor Authentication
- Appendix G: FAQs
- Appendix H: Keyboard Shortcuts

CHAPTER 3: CONFIGURING CC-SG WITH GUIDED SETUP 19
b. In the Available list, select the device you want to add to the group, and then click Add
to move the device into the Selected list. Devices in the Selected list will be added to the
group.
• If you want to remove a device from the group, select the device name in the Selected list,
and then click Remove.
• You can search for a device in either the Available or Selected list. Type the search terms in
the field below the list, and then click Go.
Describe Devices
a. Click the Describe Devices tab in the Add Devices Groups panel. In the Describe
Devices tab, you create a table of rules that describe the devices you want to assign to the
group.
b. Click the Add New Row icon
to add a row to the table.
c. Double-click the cell created for each column to activate a drop-down menu. Select the
rule components you want to use from each list.
d. Check the Create Full Access Policy for Group checkbox if you want to create a policy
for this device group that allows access to all nodes and devices in the group at all times
with control permission.
e. If you want to add another device group, click Apply to save this group, and then repeat
the steps in this section to add additional device groups.
f. When you have finished adding device groups, click OK. The Nodes Group Manager
panel opens. You can also click Create Groups, and then click Add Node Groups in the
Guided Tasks tree view in the left panel to open the Node Groups Manager panel.
g. In the Group name field, type a name for a node group you want to create.
h. There are two ways to add nodes to a group, Select Nodes and Describe Nodes. The
Select Nodes section allows you to select which nodes you want to assign to the group by
selecting them from the list of available nodes. The Describe Nodes section allows you to
specify rules that describe nodes, and the nodes whose parameters follow those rules will
be added to the group.