Owner's manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Accessing CC-SG
- Chapter 3: Configuring CC-SG with Guided Setup
- Chapter 4: Creating Associations
- Chapter 5: Adding Devices and Device Groups
- Chapter 6: Configuring Nodes and Interfaces
- Chapter 7: Adding and Managing Users and User Groups
- Chapter 8: Policies
- Chapter 9: Configuring Remote Authentication
- Chapter 10: Generating Reports
- Audit Trail Report
- Error Log Report
- Access Report
- Availability Report
- Active Users Report
- Locked Out Users Report
- User Data Report
- Users in Groups Report
- Group Data Report
- AD User Group Report
- Asset Management Report
- Node Asset Report
- Active Nodes Report
- Node Creation Report
- Query Port Report
- Active Ports Report
- Scheduled Reports
- CC-NOC Synchronization Report
- Chapter 11: System Maintenance
- Chapter 12: Advanced Administration
- Appendix A: Specifications (G1, V1, and E1)
- Appendix B: CC-SG and Network Configuration
- Appendix C: User Group Privileges
- Appendix D: SNMP Traps
- Appendix E: Troubleshooting
- Appendix F: Two-Factor Authentication
- Appendix G: FAQs
- Appendix H: Keyboard Shortcuts

40 COMMANDCENTER SECURE GATEWAY ADMINISTRATOR GUIDE
operation. You can upgrade the device firmware after adding the device to CC-SG. Please
refer to Upgrade Devices later in this chapter for additional information.
Edit Device
You can edit a device to rename it and modify its properties.
1. Click the Devices tab and select the device you want to edit. The Device Profile screen
appears.
Figure 35 The Device Profile Screen
2. Type the new device properties in the appropriate fields on this screen. If necessary, edit the
Categories and Elements associated with this device.
3. Click OK to save your changes. A Device Updated Successfully message confirms that the
device has been modified.
Edit PowerStrip Device
You can edit a Managed PowerStrip device to rename it, modify its properties, and view outlet
configuration status.
1. Click the Devices tab and select the PowerStrip device you want to edit. The Device Profile:
PowerStrip screen appears.
2. Type the new device properties in the appropriate fields on this screen. If necessary, edit the
Categories and Elements associated with this device.
3. Click the Outlet tab to view all outlets of this PowerStrip.
• If an outlet is associated with a node, you can click the Node hyperlink to open the Node
Profile.
• If an outlet is associated with a node, you can select the outlet, and then click Power
Control to open the Power Control screen for the associated node.
4. Click OK to save your changes. A Device Updated Successfully message confirms that the
device has been modified.