Owner's manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Accessing CC-SG
- Chapter 3: Configuring CC-SG with Guided Setup
- Chapter 4: Creating Associations
- Chapter 5: Adding Devices and Device Groups
- Chapter 6: Configuring Nodes and Interfaces
- Chapter 7: Adding and Managing Users and User Groups
- Chapter 8: Policies
- Chapter 9: Configuring Remote Authentication
- Chapter 10: Generating Reports
- Audit Trail Report
- Error Log Report
- Access Report
- Availability Report
- Active Users Report
- Locked Out Users Report
- User Data Report
- Users in Groups Report
- Group Data Report
- AD User Group Report
- Asset Management Report
- Node Asset Report
- Active Nodes Report
- Node Creation Report
- Query Port Report
- Active Ports Report
- Scheduled Reports
- CC-NOC Synchronization Report
- Chapter 11: System Maintenance
- Chapter 12: Advanced Administration
- Appendix A: Specifications (G1, V1, and E1)
- Appendix B: CC-SG and Network Configuration
- Appendix C: User Group Privileges
- Appendix D: SNMP Traps
- Appendix E: Troubleshooting
- Appendix F: Two-Factor Authentication
- Appendix G: FAQs
- Appendix H: Keyboard Shortcuts

CHAPTER 5: ADDING DEVICES AND DEVICE GROUPS 57
IP-Reach and UST-IP Administration
You can also perform administrative diagnostics on IP-Reach and UST-IP devices connected to
your Paragon System setup directly from the CC-SG interface.
After adding the Paragon System device to CC-SG, it appears in the Devices tree.
To access Remote User Station Administration:
1. Click the Device tab, and then select the Paragon II System Controller.
2. Right-click the Paragon II System Controller, and then click Remote User Station Admin.
The Remote User Station Admin screen appears, listing all connected IP-Reach and UST-IP
units.
3. Click the Launch Admin button in the row of the device you want to work with to activate
Raritan Remote Console and launch the blue device configuration screen in a new window.
Figure 56 IP-Reach Administration Screen