Owner's manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Accessing CC-SG
- Chapter 3: Configuring CC-SG with Guided Setup
- Chapter 4: Creating Associations
- Chapter 5: Adding Devices and Device Groups
- Chapter 6: Configuring Nodes and Interfaces
- Chapter 7: Adding and Managing Users and User Groups
- Chapter 8: Policies
- Chapter 9: Configuring Remote Authentication
- Chapter 10: Generating Reports
- Audit Trail Report
- Error Log Report
- Access Report
- Availability Report
- Active Users Report
- Locked Out Users Report
- User Data Report
- Users in Groups Report
- Group Data Report
- AD User Group Report
- Asset Management Report
- Node Asset Report
- Active Nodes Report
- Node Creation Report
- Query Port Report
- Active Ports Report
- Scheduled Reports
- CC-NOC Synchronization Report
- Chapter 11: System Maintenance
- Chapter 12: Advanced Administration
- Appendix A: Specifications (G1, V1, and E1)
- Appendix B: CC-SG and Network Configuration
- Appendix C: User Group Privileges
- Appendix D: SNMP Traps
- Appendix E: Troubleshooting
- Appendix F: Two-Factor Authentication
- Appendix G: FAQs
- Appendix H: Keyboard Shortcuts

CHAPTER 6: CONFIGURING NODES AND NODE GROUPS 73
Connect to a Node
Once a node has an interface, you can connect to that node through the interface in a number of
ways. Please refer to Raritan’s CommandCenter Secure Gateway User Guide for additional
information.
Figure 70 Connecting to a Node's Configured Interface
1. Click the Nodes tab.
2. Select the node you want to connect to. The Node Profile screen appears.
3. In the Interfaces table, click the name of the interface you want to connect with.
Alternatively:
1. In the Nodes tab, click the + symbol next to the node you want to connect to, expanding the
list of interfaces underneath it.
2. Double-click the name of the interface you want to connect with.
Edit an Interface
To edit an interface:
1. Click the Nodes tab.
2. Click the node with the interface you want to edit. The Node Profile screen appears.
3. In the Interfaces table, select the row of the interface you want to edit.
4. Click Edit. The Edit Interface screen appears.
Figure 71 Editing an Interface