User's Manual

Chapter 6: Device Management
152
Tip: Enable or disable entire Categories by checking or clearing the
Category checkboxes, respectively.
3. Click OK.
To reset to factory defaults:
• Click Reset To Defaults.
Warning: When using SNMP traps over UDP, it is possible for the KX
II-101 and the router that it is attached to to fall out of synchronization
when the KX II-101 is rebooted, preventing the reboot completed
SNMP trap from being logged.
SNMP Agent Configuration
SNMP-compliant devices, called agents, store data about themselves in
Management Information Bases (MIBs) and return this data to the SNMP
managers. Use the Event Logging page to configure the SNMP
connection between the KX II-101 (SNMP Agent) and an SNMP
manager.
SNMP Trap Configuration
SNMP provides the ability to send traps, or notifications, to advise an
administrator when one or more conditions have been met. The following
table lists the KX II-101 SNMP traps:
Trap Name Description
configBackup The device configuration has been backed up.
configRestore The device configuration has been restored.
deviceUpdateFailed Device update has failed.
deviceUpgradeCompleted The KX II-101 has completed update via an RFP
file.
deviceUpgradeStarted The KX II-101 has begun update via an RFP file.
factoryReset The device has been reset to factory defaults.
firmwareFileDiscarded Firmware file was discarded.
firmwareUpdateFailed Firmware update failed.
firmwareValidationFailed Firmware validation failed.
groupAdded A group has been added to the KX II-101 system.
groupDeleted A group has been deleted from the system.
groupModified A group has been modified.
ipConflictDetected An IP Address conflict was detected.