User's Manual

Chapter 6: Device Management
163
6. Click OK to configure the analog KVM switch.
To restore analog KVM switch defaults:
• Click Reset to Defaults.
Resetting the KX II-101 Using the Reset Button
On the back panel of the KX II-101, there is a Reset button. It is
recessed to prevent accidental resets (you will need a pointed object to
press this button).
The actions that are performed when the Reset button is pressed are
defined in the graphical user interface. See Encryption & Share (on
page 190).
To reset the device:
1. Power off the KX II-101.
2. Use a pointed object to press and hold the Reset button.
3. While continuing to hold the Reset button, power the KX II-101
device back on.
4. Continue holding the Reset button for 5-10 seconds.
5. Release the Reset button and the KX II-101 will reboot. This typically
takes three minutes.