- Raritan Paragon II User Guide

CHAPTER 2: INSTALLATION 9
Function Selection Screen:
Several administrative functions can be performed on the Function Selection Screen on the
Paragon II unit’s front panel.
Display Ver./SN
Test User UST1
Test Chan. UKVM
Test Stack Unit
Stacking Support
Set LCD Contrast
Re-Configure
Set IP Address
Reset Unit
Figure 10 LCD Functions
Selecting a Function:
Press the FUNC button on the front panel of the Paragon II unit to enter Function Selection mode
and use the Ç and È buttons to scroll through the Function List. Press the ENT button on the
front panel to select displayed function and use the instructions below for each specified function.
Press the ESC button on the front panel at any time to return to Normal Display.
Function Menu
Display Ver./SN
Figure 11 Function Selection
1. Display Ver./SN (Firmware Version and Serial Number): Displays current version of
firmware, the firmware loader, the unit’s serial number, and the field programmable gate
array (FPGA).
Firmware: 2C1
SN: CPB80347
Figure 12 Display Ver. and SN
2. Test User UST1 (User Station): Used by administrator to check if user stations (UST1s) are
functioning properly. Press the Ç or È button to change user port number. Display will read
“OK”, “None”, or “Failed. Press ESC to return to normal display.”
If a “failed” condition is detected, make sure Category 5e UTP cable is installed properly and
secured, or try using another UST1 to see if UST1 under test has become defective.
Test User UST1
UST1: 3 OK
Figure 13 User Station Test