- Raritan Paragon II User Guide

CHAPTER 2: INSTALLATION 15
C. The OSUI’s Selection Menu appears, indicating that the User Station is correctly
installed.
Figure 20 Selection Menu
4. Repeat steps 2 and 3 for each User Station you want to connect to the Base Unit.
5. Connect a P2CIM-PS2 and its server CPU.
A. Connect the cable strands of an appropriate P2CIM-PS2 to the desired ports on a server
CPU:
1. P2CIM-PS2 (IBM PS/2 compatible CPUs): Plug the HD15 strand into the CPU’s
HD15 VGA video port. Plug the purple 6-pin mini-DIN keyboard strand into the
CPU’s 6-pin mini-DIN keyboard port. Plug the light green 6-pin mini-DIN strand
into the CPU’s 6-pin mini-DIN mouse port.
2. P2CIM-SUN (Sun compatible CPUs): Plug the HD15 strand into the CPU’s HD15
VGA video port. Plug the 8-pin mini-DIN strand into the CPU’s 8-pin mini-DIN
keyboard/mouse port.
3. P2CIM-USB (USB CPUs of any platform, P2 CIM-SUSB, or P2CIM-USBG2): Plug
the HD15 strand into the CPU’s HD15 VGA video port. Plug the USB Type A strand
into one of the CPU’s USB Type A ports. The P2CIM-USBG2 comes with a toggle
switch that allows users to switch between PC/MAC USB configurations and SUN
USB configurations.
4. P2CIM-PS2DUAL (IBM PS/2 compatible CPUs): Connect keyboard, monitor, and
mouse cables attached to the P2CIM-PS2DUAL to the appropriate 15-pin female
video port and 6-pin mini-DIN mouse and keyboard ports on the computer.
5. AUATC (serial CPUs, routers, etc.): Please see Appendix E: Using AUATC for
RS-232 Access for installation instructions.
6. Z-CIM (local single-user IBM PS/2 compatible CPUs): Please see Chapter 5:
Paragon II and Z-CIMs for installation instructions.
B. Plug in and power ON the CPU. If the P2CIM-PS2 is installed and operating properly,
the P2CIM-PS2’s green LED will start blinking: once per second while the P2CIM-PS2
is idle, more quickly while data is passed in either direction.
C. Connect one end of a CAT5 UTP cable to RJ45 port #1 on the back of the Base Unit.
Connect the other end of cable to the RJ45 port on the P2CIM-PS2.
6. Configure the P2CIM-PS2 and the attached CPU.
A. The monitor attached to the User Station will display the Selection Menu; with the CPU
you just connected displayed in green. Use the Ç and È keys to move the highlight to
that entry and press ENTER. If you can access and operate the CPU normally, the
P2CIM-PS2 is connected successfully. Raritan recommends you give the server a
meaningful system name at this time, as described in the next steps.