- Raritan Paragon II User Guide

18 PARAGON II USER GUIDE
plug in and power ON your master Base Unit. Following steps 2B, 2C, and 2E of Installing a
Paragon System with a Single Base Unit, plug in and power ON your User Stations and
monitors. The master Base Unit should automatically recognize the connected subsidiary
Base Units and update its configuration. All monitors should display the Login Menu. If any
monitors instead display a “.....No connection to Paragon.....” message, the User Station they
are attached to is not properly connected to the master Base Unit. Check for loose
connections and make sure you are using good, intact CAT5 cables. (See Appendix A:
Specifications for UTP-cabling information.)
Note: If your video image is fuzzy (especially if you are using an LCD flat-panel monitor), you
can adjust the video gain to focus the video image. If the OSUI is not already on screen at a given
monitor, activate it by pressing the Scroll Lock key twice rapidly, then use the numeric keypad’s
+ and – (plus and minus) keys to adjust the video image until it appears to be in focus. The P2-
EUST provides manual skew compensation, which will also help improve video quality. Please
see Chapter 3: Operation – User Functions, Manual Video Gain and Skew Compensation in
P2-EUST for additional information.
6. Configure the channel ports in your system. (Check the Scroll Lock LED on one of your
user-station keyboards. If it is blinking, the Paragon is ready to accept hotkey commands
from that user station. Hotkey commands can be used with the OSUI to login, select servers,
or administer the system.)
A. At the Login Menu, type admin in the User Name field and press the Enter key. In the
Password field, type the default password raritan (all lowercase) and press the Enter
key.
B. The monitor will display the Selection Menu, indicating that the User Station is correctly
installed.
Figure 24 Selection Menu