- Raritan Paragon II User Guide

CHAPTER 5: PARAGON II AND Z-CIMS 61
Paragon II and UKVMSPD Z-CIMs
Using a UKVMSPD with a Local PC
To grant specific access to a local PC from a certain user station and to access the Paragon system
CPUs also, insert a UKVMSPD dual-access CIM between a User Station and a Base Unit.
1. If you have not already done so, install your Paragon system as described in Chapter 2:
Installation.
2. Disconnect the cable that connects the User Station to the Base Unit from the Base Unit’s
user port.
3. Connect the free end of this cable to the UKVMSPD RJ45 port labeled “UTP OUT.”
4. Connect another CAT5e cable from the UKVMSPD RJ45 port labeled “UTP IN” to the Base
Unit’s user port (where you just disconnected the other cable).
5. Plug the UKVMSPD HD15 strand into the HD15 VGA video port of the CPU you want to
access. Plug the purple 6-pin mini-DIN keyboard strand into the CPU’s 6-pin mini-DIN
keyboard port. Plug the light green 6-pin mini-DIN strand into the CPU’s 6-pin mini-DIN
mouse port.
6. Plug in and power ON the CPU. If the UKVMSPD is installed and operating properly, the
UKVMSPD green LED will start blinking (once per second when the UKVMSPD is idle,
more quickly while data passes in either direction).
Once this installation is finished, activate Local PC Mode on the User Station:
1. Log on at the attached user station.
2. Press the hotkey (Scroll Lock) twice rapidly to activate the OSUI.
3. Press F4 to activate the User Profile Menu.
Figure 54 User Profile Menu
4. Use TAB or the Ç and È keys to move the highlight to the Local PC field.
5. Press ENTER. The Local PC field will turn green.
6. Use the Ç or È to toggle the value of the field to “On.”
7. Press ENTER. The highlight will turn yellow.
8. Press S to save the change and return to the User Profile Menu. If you do not wish to save
changes, press the ESC key to abort the change and return to the User Profile Menu.
Once Local PC Mode is turned on, you can access the dedicated local PC CPU from this user
station by pressing the Home key twice rapidly while viewing the OSUI. The User Station will
immediately switch you to the local PC. To return to the Paragon system and its switched CPUs,
activate the OSUI by pressing the hotkey twice (Scroll Lock), then press F2 to activate the
Selection Menu and access any of the listed servers.