User guide

Dominion KX I Dominion KX II

RPC (Existing)

P2CIM-PWR D2CIM-PWR

Dominion PX (New)

 DCIM-USBG2 – Basic USB CIM

The DCIM-USBG2 is a basic, VGA-based USB CIM for customers not wanting virtual media, absolute

mouse or the other advanced features. The Paragon II equivalent is the P2CIM-AUSB. The

information below also applies to this CIM, which can be used with the Dominion KX II.

The DCIM-USBG2 is the second generation basic USB CIM, with enhanced reliability and performance.

The DCIM-USBG2 supports both USB and SUN USB. A small switch on the unit determines USB or

SUN USB. For Windows targets, the “P” setting should be used. For Sun targets, the “S” setting

should be used. For other OS’, start with the “P” position. If the keyboard and/or mouse do not

operate correctly, switch to the “S” position.

Important Note: You must power cycle the CIM if you change the switch setting while the CIM is

connected to the target server.

Steps to power cycle the CIM:

1. Remove the USB connector from the target server. The video connector can remain in place.

2. Wait 5 seconds.

3. Reconnect the USB connector.

You can configure the CIM using a setup menu for various operating modes, such as keyboard and

mouse types and keyboard language. See the appendix at the end of this document for more

information.

The DCIM-USBG2 can be used for both KX I and KX II. It is a low cost CIM, but lacks the virtual

media, absolute mouse, smart card, and tiering features of the D2CIM-DVUSB.