User guide

Chapter 11: Command Line Interface (CLI)
178
Command Option
Description
verbose [on|off]
Turns verbose logging on and off.
Setlog Command Example
The following Setlog command sets the logging level to debug with
verbose logging on for the libpp_serial module.
Setlog module libpp_serial level debug verbose on
Configuration
The Configuration menu enables you to access the network commands
used to configure the network interface and set the device name.
Network
The Configuration > Network commands are used to configure the KX II-
101-V2 network connection and device name.
Command
Description
interface
Configure the KX II-101-V2 device
network interface.
name
Set the device name.
ipv6_interface
Set/get IPv6 network parameters.
Interface Command
The interface command is used to configure the KX II-101-V2 network
interface. When the command is accepted, the device will drop the
HTTP/HTTPS connection and initialize a new network connection. All
HTTP/HTTPS users must reconnect to the device using the new IP
address and the correct username and password. See Installation and
Configuration (on page 9).
The syntax of the interface command is:
interface [ipauto <none|dhcp>] [ip <ipaddress>]
[mask <subnetmask>] [gw <ipaddress>] [mode
<auto/10hdx/10fdx/100hdx/100fdx]
The network command options are described in the following table.