User guide

Chapter 11: Command Line Interface (CLI)
179
Command Option
Description
ipauto
Static or dynamic IP address
ip ipaddress
IP address of the KX II-101-V2 assigned
for access from the IP network
mask subnetmask
Subnet mask obtained from the IP
administrator
gw ipaddress
Gateway IP address obtained from the
IP administrator
mode <auto | 100fdx>
Set Ethernet Mode to auto detect or
force 100MB/s full duplex (100fdx)
Interface Command Example
The following command sets the IP address, mask, and gateway
addresses, and sets the mode to auto detect.
Admin Port > Config > Network > interface ipauto
none ip 192.168.50.12 mask 255.255.255.0 gw
192.168.51.12 mode auto
Name Command
The name command is used to configure the unit and host name.
Syntax
name [unitname name] [domain name] [force
<true|false>]
name Command Example
The following command sets the unit name:
Admin Port > Config > Network > name unitname <unit
name> domain <host name> force trues
IPv6 Command
Use the IPv6_command to set IPv6 network parameters and retrieve
existing IPv6 parameters.
Ipv6_interface mode enable ipauto none ip
2001:db8:290c:1291::17 prefixlen 128 gw
2001:db8:290c:1291::1