User guide

Chapter 7: Using the Command Line Interface
146
Showing Information
You can use the show commands to view current settings or status of the
Dominion PX device or part of it, such as the IP address, networking mode,
firmware version, circuit breaker state, inlet ratings, and so on.
Many show commands have two formats: one with the parameter "details"
and the other without. The difference is that the command without the
parameter "details" displays a shortened version of information while the
other displays in-depth information.
After typing a show command, press Enter to execute it.
Note: Depending on your login name, the # prompt may be replaced by the
> prompt.
Network Configuration
This command shows the network configuration, such as the IP address,
gateway, and subnet mask.
# show network
To show detailed information, add the parameter "details" to the end of the
command.
# show network details
Wireless Configuration
This command shows the wireless configuration of the Dominion PX
device, such as the SSID parameter.
# show wireless
To show detailed information, add the parameter "details" to the end of the
command.
# show wireless details