User guide

Chapter 7: Using the Command Line Interface
152
Circuit Breaker Sensor Information
This command is NOT available for a PDU without any overcurrent
protection mechanism.
This command syntax shows the specified circuit breaker sensor's
information.
# show sensor ocp <n> <sensor type>
To show detailed information, add the parameter "details" to the end of the
command.
# show sensor ocp <n> <sensor type> details
Variables:
 <n> is the number of the circuit breaker whose sensors you want to
query.
 <sensor type> is one of the following sensor types:
Sensor type Description
current Current sensor
Displayed information:
 Without the parameter "details," only the reading, state, threshold and
hysteresis settings of the specified circuit breaker sensor are
displayed.
 With the parameter "details," more sensor information is displayed,
including accuracy, resolution, tolerance, and range.
 If the requested sensor type is not supported, the message "Sensor is
not available" is displayed.