User guide

Chapter 7: Using the Command Line Interface
153
Environmental Sensor Information
This command syntax shows specified environmental sensor's
information.
# show sensor externalsensor <n>
To show detailed information, add the parameter "details" to the end of the
command.
# show sensor externalsensor <n> details
Variables:
 <n> is the environmental sensor number. The environmental sensor
number is the ID number assigned to the sensor, which can be found
on the External Sensor page of the PDU's web interface.
Displayed information:
 Without the parameter "details," only the reading, state, threshold,
hysteresis and assertion delay settings of the specified environmental
sensor are displayed.
 With the parameter "details," more sensor information is displayed,
including accuracy, resolution, tolerance, and range.
 If the requested sensor type is not supported, the message "Sensor is
not available" is displayed.
Note: For a discrete (on/off) sensor, only the sensor type and state are
displayed no matter which command is performed.