User guide

Chapter 2: Rack-Mounting the PDU
5
Mounting Zero U Models Using Two Rear Buttons
The following describes how to mount a PDU using two buttons only.
To mount Zero U models using two buttons:
1. Turn to the rear of the PDU.
2. Locate two screw holes on the rear panel: one near the bottom and
the other near the top (the side of cable gland).
3. Screw a button in the screw hole near the bottom. The recommended
torque for the button is 1.96 N·m (20 kgf·cm).
4. Screw a button in the screw hole near the top. The recommended
torque for the button is 1.96 N·m (20 kgf·cm).