User guide

Chapter 7: Using the Command Line Interface
193
Pole Label
<p>
Current sensor Voltage sensor
2
L2
L2 L2 - L3
3
L3
L3 L3 - L1
 <sensor type> is one of the following sensor types:
Sensor type Description
current Current sensor
voltage Voltage sensor
activePower Active power sensor
apparentPower Apparent power sensor
powerFactor Power factor sensor
activeEnergy Active energy sensor
unbalancedCurrent Unbalanced current sensor
Note: If the requested sensor type is not supported, the message
"Sensor is not available" is displayed.
 <value> is a numeric value that is assigned to the hysteresis for the
specified inlet pole sensor. See What is Deassertion Hysteresis?
(on page 100) for how the deassertion hysteresis works.
Example
The following command sets the deassertion hysteresis for the pole 2
(L2-L3) voltage of the inlet 1 to 0.5A.
config:# sensor inletpole 1 L2 current hysteresis 0.5
Commands for Circuit Breaker Sensors
A sensor configuration command for circuit breakers begins with sensor
ocp.