User guide

Chapter 7: Using the Command Line Interface

216

Unblocking a User

If any user is blocked from accessing Dominion PX, you can unblock them

over a serial connection.

To unblock a user:

1. Log in to the CLI interface using any terminal program via a serial

connection. See With HyperTerminal (on page 143).

Whe

n the Username prompt appears, type unblock and press Enter.

3. When the "Username to unblock" prompt appears, type the login

name of the user to be unblocked and press Enter.

4. A message appears, indicating that the specified user was unblocked

successfully.

Resetting Dominion PX

You can reset Dominion PX to factory defaults or simply restart it using the

CLI commands.

Restarting the PDU

This command restarts the Dominion PX device. It is not a factory default

reset.

To restart the Dominion PX device:

1. Ensure you have entered the administrator mode and the # prompt is

displayed.

2. Type either of the following commands to restart the Dominion PX

device.

# reset pdu unit

-- OR --

# reset pdu unit /y

3. If you entered the command without "/y" in Step 2, a message

appears prompting you to confirm the operation. Type y to confirm the

reset.

4. Wait until the Username prompt appears, indicating the reset is

complete.