User guide

Chapter 5: Using the Web Interface
65
2. Click New. The Create New User dialog appears.
3. Type the information about the user in the corresponding fields. Note
that User Name, Password and Confirm Password fields are required.
Field Type this...
User Name The name the user enters to log in to Dominion PX.
 The name can be 4 to 32 characters long.
 It is case sensitive.
 Spaces are NOT permitted
Full Name The user's first and last names.
Password,
Confirm Password
The password the user enters to log in. Type it first
in the Password field and then again in the Confirm
Password field.
 The password can be 4 to 32 characters
long.
 It is case sensitive.
 Spaces are permitted.
Telephone Number A phone number where the user can be reached.
eMail Address An email address where the user can be reached.
 The email can be up to 32 characters long.
 It is case sensitive.
4. Select the Enabled checkbox. If not, the user CANNOT log in to the
Dominion PX device.
5. Select the "Force password change on next login" checkbox if you
prefer a password change by the user when the user logs in for the
first time after this checkbox is enabled.
6. Click the SNMPv3 tab to set the SNMPv3 access permission. The
permission is disabled by default.
a. To permit the SNMPv3 access by this user, select the "Enable
SNMPv3 access" checkbox. Otherwise, leave the checkbox
disabled.
Note: The SNMPv3 protocol must be enabled for SNMPv3 access.
See Configuring the SNMP Settings (on page 58).
b. Set up SNMPv3 parameters if enabling the SNMPv3 access
permission.
Field Description
Security Level Click the drop-down arrow to select a preferred