User guide

Chapter 11: Command Line Interface
144
PMON Version: 2.0.1
RSC Version: 1.0.0.1.16
Supporting software:
OpenSSH_4.3p2, OpenSSL 0.9.7i 14 Oct 2005
HTTP Server version: Apache/2.2.0
HTTP Server built: Mar 29 2006 16:06:30
TELNET Linux NetKit 0.17
Note: SX security is not impacted if the version of Apache 2.2 installed
on the remote host is older than 2.2.9.
Initial Configuration
SX units come from the factory with default factory settings. When you
first turn on and connect to the unit, you must set the following basic
parameters so the unit can be accessed securely from the network:
1. Reset the administrator password.
All SX units are shipped with the same default password; therefore,
to avoid security breaches it is imperative that you change the admin
password from “raritan” to one customized for the administrators who
will manage the SX.
Passwords are case sensitive and can contain up to 64 alphanumeric
characters with the exception of " ' < > \ &
2. Assign the IP address, subnet mask, and gateway IP address to
allow remote access.
3. Set the time and date.
After the preceding parameters are set, the rest of the system
configuration can be performed.
Setting Parameters
To set parameters, you must be logged on with administrative privileges.
At the top level, you will see the "Username" > prompt, which for the
initial configuration is "admin". Enter the top command to return to the
top menu level.
Note: If you have logged on with a different user name, that user name
will appear instead of admin.