User guide

Chapter 11: Command Line Interface
179
ports config Command Example
admin > ports >config port 1 name ld1 bps 115200
parity odd flowcontrol hw detect true escapemode none
emulation VT100
The following command displays the current settings for port 1:
admin > Config > Port > config port 1
Port number 1:
Name: Port1
BPS: 9600
Parity: 0
Flow control: 0
RSC Terminal Emulation: VT100
Disconnect: Disabled
Application: RaritanConsole
Exit String:
Escape: Control-]
DPA:
IP: 0.0.0.0
Telnet Port: 0
SSH Port: 0
Always Active: False
Messages suppressed: none
The following example configures DPA port settings when the you
choose DPA mode IP. The IP Address is assigned for direct port access
using the following command:
admin > Config > Port > config port 1 dpaip 10.0.13.1
admin > Config > Services > dpa mode IP (upper case for
IP!)
After this option is enabled, the SX unit is restarted. DPA changes will
not be available until after the SX is rebooted.
ssh -l sx_user 10.0.13.1
Password: